Laserfiche WebLink
The entry/egress door shall be provided with a Cleer Vision Brand 20" wide x 19" <br />high horizontally sliding window. It shall have tempered automotive privacy safety <br />glass and shall have a locking mechanism to keep the window panels in the desired <br />position. A screen shall be provided, to prevent airborne particles from entering the <br />vehicle, when the window panels are in the open position. <br />Y N <br />6.25 FIXED WINDOWS <br />The rear patient entry doors shall each be provided with a Cleer Vision Brand 20" <br />wide x 19" high fixed window panel. Each window shall have tempered automotive <br />privacy safety glass. <br />6.26 SIDE BODY WINDOW Y�C N <br />A fixed, privacy automotive glass window shall be provided a Cleer Vision Brand in <br />the right body side, above the rear wheel well in the upper body side. It shall be <br />approximately 36" wide x 18" high. Y l� X <br />N <br />6.27 POCKET WHITEBOARD <br />A pocketed privacy slide shall be provided on the curbside wall. It shall be <br />incorporated into the side body window and shall slide into the wall rearward of the <br />window. When in use, the writing board shall cover the window. There will be a pad <br />covering the rear end of the privacy slide frame that the writing board will slide <br />behind. <br />Y_NX_ <br />7.0 EXTERIOR COMPARTMENT FABRICATION <br />All exterior compartments, excluding backboard compartments, shall be constructed <br />of .100" aluminum diamond plate walls and ceilings with .125" smooth aluminum <br />floors, formed and Heli arc welded. Exterior compartments are welded to both the <br />inside wall vertical structure and floor structure components for strength and <br />durability. Each floor shall be "sweep out" design. <br />YX—N_ <br />7.0.1 All exterior compartment doors shall be equipped with a gas charged hold open <br />door check. <br />Y4X—N_ <br />7.1 EXTERIOR COMPARTMENT DOORS <br />Each exterior compartment door shall be constructed of .125" aluminum sheet <br />double pan formed with a 1.5"' return bend with recessed offset supporting the .063" <br />3003 alloy aluminum diamond plate interior liner. Extruded doors and/or doorframes <br />are not acceptable. In addition, for maximum rigidity, 2.375" "C" channel bracing <br />shall be added internally for additional door structural integrity. The exterior face of <br />the door and the door edges shall be formed from one [1] sheet of aluminum. All <br />doors shall be flush with the body side and shall be fully insulated with polyurethane <br />spray foam. When opened, the doors will activate their respective compartment <br />lights. All compartment doors shall be keyed alike. Each access door is to be <br />stamped with an alphanumeric code; this will enable the quick and exact <br />replacement of a damaged door. The inner door panels shall be affixed to the flange <br />with stainless steel serrated spring washers and TX-25 Type F Torx-head machine <br />screws. <br />Y N <br />