Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Horton Emergency Vehicles

Home Browse Search

7.2 EXTERIOR COMPARTMENT DOOR HANDLES AND LATCHING Door hinges shall be full length stainless steel #304-213 buffed and polished with a 1/4" stainless pin and shall be fastened to the door and door frame with self-locking stainless -steel screws. Hinges are to be of a slotted style with a round hole on each leaf of the hinge for permanent lifetime adjustment of the doors. Hinges shall be staked, not welded, every 4" to prevent pin from moving. The locking mechanism shall be a Tri-Mark #13136 outside handle, #13028 inside handle with a #12765-01 gasket for the external handle with #14229-01 and #14230-01 rotary latch and #10355U adjustable Nader pin. Latches shall be near flush with the door skin. Each latch must be capable of being locked independently with an integral exterior key lock and a key matching the locks on the curbside and rear entry doors. The latch system is to be activated by the use of a .156" zinc plated steel rod with a single point threaded adjustment mechanism. Systems operated by cables are unacceptable due to the tendency of cable to stretch or fatigue prematurely. The latch and the Nader pin shall be mounted so as not to interrupt the continuous door seal. A .437" hole shall be drilled into the edge of each door adjacent to the paddle handle. This lubrication access shall be sealed with a removable plastic cap for protection of the internal mechanism. 7.3 EXTERIOR OXYGEN COMPARTMENT VENT One (1) #1031 Cast Products, polished aluminum exterior oxygen compartment vent (or equal) shall be provided and installed on the door of the exterior compartment that houses the oxygen tank retention system. The vent hole shall be 3" in diameter and provide adequate ventilation for gaseous oxygen should a leak occur. A black plastic vent shall be provided and installed on the interior door liner covering the vent Y_Nk hole to protect it from intrusion by the elements when the door is open. Y CN 7.4 DRI-DECK The floor and shelf of each exterior compartment shall be covered with Dri-Deck (or equal) material that shall be black in color with a safety yellow tapered edge for the outer edge of each compartment floor. YXN 7.5 DOOR GRABBERS A set of door Cast Products "Grabbers" (or equal) shall be provided at the bottom of the rear doors. They shall be fastened to the door and door frame with self-locking stainless -steel screws. �( Y! \ N 7.6 DOOR SEALS For optimum fit and closure, the compartment and patient entry doors shall close on a .625" W x .400" thick automotive, closed cell EDPM rubber gasket adhered to first interior surface of the double pan -formed compartment doors. The gasket seal shall be located on this surface to prevent exposure of the rotary latch mechanism to water or dirt when the door is closed. Ism