Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Horton Emergency Vehicles

Home Browse Search

wheel well. It shall have the approximate dimensions as follows: 21" wide x 84" high YXN_ 6.20.1 The P5 compartment shall have a solid, flush mounted, vertically hinged door, constructed of aluminum. Y-)_"_ 6.21 REAR PATIENT ENTRY DOORS Each patient entrance door shall be constructed of .125" aluminum sheet box formed with a double return bend of 2.75" total thickness. Extruded doors and/or doorframes are not acceptable. Each door shall have the seal installed on the outer door pan flange to assure maximum sealing surface and to protect the rotary latching mechanism from environmental influences. The inner door pan liner shall be affixed to the flange with stainless steel serrated spring washers and TX-25 Type F Torx- head machine screws. In addition, "C" channel bracing shall be added internally for additional door structural integrity. Both rear patient entrance doors shall have an FMVSS 206 tested Tri-Mark locking handles keyed alike to the side entrance door and a Tri-Mark non -locking handle. Each rear door shall have a two -point rotary latch with adjustable .50" Nader pins with head flanges at the top and bottom with release handles on the interior faces of the doors. When opened, the rear doors shall provide an opening of at least 63" high and 54" wide. Each rear door shall be equipped with a Cast Products "grabber" style door check, which shall be located at the bottom of the door. When opened, the rear doors shall activate the interior dome lights and the rear exterior load lights. Each access door is to be stamped with an alphanumeric code; this will enable the quick and exact replacement of a damaged door. YXN_ 6.22 DOOR TRIM The door shall have a .090" aluminum panel covering the upper and lower door and full width door panel with .028" Formica, with color to match interior and shall be impervious to moisture, easily cleaned, durable, and attractive. The middle portion shall be stainless steel and removable for ease of maintenance. YkN 6.22.1 Each rear patient entrance door shall have a 1.5" diameter polished stainless steel 90-degree ergonomic style assist handle. Y_KN 6.23 REAR BODY CLOCK One (1) MFS-121 Digital Atomic Clock (or equal) shall be provided directly above the rear patient entrance doors, recessed into the center of the rear head pad. It shall be wired directly to the vehicle electrical system. Y�N_ 6.24 SLIDING WINDOW