Laserfiche WebLink
SHALL BE <br />Jones AS <br />_ <br />TYPE DESCRIPTION ON SPECIFIED <br />(Circle One) <br />The output shaft shall be coupled to the auger tube with a UHMW <br />bushing and a 7/8" G8 bolt. The 2" idler shaft shall couple to the auger <br />tube with a UHMW bushing and 7/8" bolt. The idler bearings shall be 2" <br />ID, four bolt flange type and greaseable. <br />The auger system shall not extend past the tailgate of the body so as to <br />allow for future additions of rear spreader and/or body attachments. <br />Integral rear body extensions or tail shelf is not acceptable. <br />Bottom Screens: There shall be Heavy Duty bottom grates constructed of <br />3/8" rod welded to form a 2.5" square mesh which is formed by a <br />combination of/4" x 1-1/2" flat steel and 2" angle iron with edge <br />supports reinforced with'/4" x 1" flat bar. Bottom grates shall <br />incorporate a safety lock system to prevent easy access to the inside of <br />the body. Grates shall be installed over the dual auger discharge system. <br />The grates shall not interfere with the discharge of wet sand. <br />Cover Plate: There shall be a removable 1/4" AR400 steel auger floor cover provided to YES NO <br />g <br />install over the augers to allow rebar and other chain abrasive materials � <br />to be hauled without damaging the augers. Cover shall be slide in type. <br />Spinner: The spinner assembly shall be manufactured from 201 stainless steel. YES' NO <br />hrrv�m����a�d� <br />Spinner shall be chassis frame mounted. A vertical pipe shall be <br />mounted to the chassis frame and allows the spinner to swing under <br />and out of the way when spinner is not in use. <br />Entire spinner assembly shall be removable without the use of tools. <br />The spinner assembly shall have adjustable deflectors manufactured <br />from 3/16" stainless steel. <br />The spinner motor shall be high torque/low speed mounted directly to <br />the spinner disc with a cast hub. <br />The spinner disc shall be 20" in diameter and manufactured of <br />polyurethane. <br />Spinner motor shall be installed with seal savers. <br />This arm shall have two positions; one under the conveyor to receive <br />material, the other position will be stowed under the chassis. The mount <br />shall bolt onto the truck so it can be removed for the truck to back into <br />the City's paver. <br />13 <br />