Laserfiche WebLink
o� <br />III iii � � .°��� a� ii�� ������� �u��� ,�� (°��������� ° � Cn� SHALL BE <br />� AS <br />TYPE DESCRIPTION SPECIFIED <br />(Circle One) <br />Vibrator: There shall be a vibrator mounted to the underside of the <br />dump body. Vibrator should include mounting plate and safety chain. <br />Reflective Tape: There shall be a 2" reflective tape installed both bottom <br />sides and at the rear of the dump body. Tailgate shall have 2" reflective <br />tape installed around the perimeter facing to the rear. <br />Spread Apron shall be three piece with the center removable and shall <br />bolt on. Apron shall be hinged so that when pulling out of spreader it <br />will slide upwards. Spreader apron shall extend 12" and shall be <br />constructed of 7 gauge 201 #4stainless steel. <br />dtlW� w�o �F <br />Tailgate: The tailgate shall be constructed of 7 gauge 201 #4 stainless steel with a YESNO <br />boxed perimeter. The tailgate shall be double acting and have two 11..11��N)1 <br />vertical and one horizontal brace to form a six -panel design. The tailgate <br />shall have 1-1/4" hardened pins. <br />The tailgate latches shall be 1/z" thick, with each latch being adjustable. <br />The tailgate shall be air release type. There shall be 2 air cylinders for the <br />tailgate release, and they shall be located one in each side of the body <br />rear post with an access panel. <br />The tailgate shall be air release type. There shall be 2 air cylinders for the <br />tailgate release, and they shall be located one in each side of the body rear <br />post with an access panel. <br />Floor: The floor shall be made of 201 7-gauge stainless steel. <br />Note: In order to assure City's leaf box will fit, there shall not be over a <br />2" radius between sides and floor of dump body. It shall be bidder's <br />obligation to insure existing leaf boxes will fit quoted body. <br />Discharge Twin augers shall convey material to rear of body. The unit shall have a <br />System: 1/4" 201 stainless steel replaceable trough with two V-shaped troughs for <br />the two augers. <br />There shall be two step -flighted augers, one RH helical and one LH <br />helical. Augers shall be 7" OD X 4" ID with 1/2" flighting on a Schedule <br />80 pipe. The flighting shall be 1/z" thick, hard surfaced to minimum of <br />55 Rockwell hardness. Each auger shall be driven by a 24.9 CI motor <br />with a 1-1 /4" 14T splined shaft and ORB ports. The motors shall direct <br />couple to a 3.6:1 planetary gear box with a 2-1/2" output shaft. Gearbox <br />"float" mount shall be designed to compensate for any misalignment. <br />12 <br />YES)NiO <br />N.e11d.", <br />(YES)NO <br />