Opening of Bids - Spec S - One or More 2018 or Newer Emergency Medical Vehicle - Horton Emergency Vehicle - Part 2

Home Browse Search

Dimensions shall allow for easy removal of device from holder. A seat belt style retaining strap shall be secured to the back with footman loops. The stair chair holder shall be mounted into the compartment with two (2) 300 tbs., full extension ball bearing drawer slid Y 7N- 7.18 SAFETY REFLECTORS A 4.5" wide x, V high red reflector shall be provided and installed on the inside, lower outboard area of each exterior door. These reflectors shall warn oncoming traffic of the open door while on scene. 7.19 GRAB RAIL An exterior style 16" stainless steel grab rail shall be installed on the curbside of the vehicle to the rear of the curbside entrance door. The grab rail shall be bolted through the body skin and through the aluminum side structure with fender washers and lock nuts on the interior and rubber gaskets under the feet of the grab rail on the exterior. A grab rail mounted to the body skin is unacceptable. 7.20 SIDE BODY SEAMS All side center body seams are to be MIG welded, fully filled and body finished to create a smooth, blemish, free surface for final finishing and painting. There shall be no side body molding applied or required. 10 Y VN_ 1,21 REAR BUMPER The rear step bumper shall be approximately 94" wide and step tread depth of 10.5". The bumper shall be supported with a 1.5" x 1.5" x .250" wall steel tube sub frame and have .250" steel angle outer frame construction. The bumper shall be bolted to the vertical web of the chassis frame rails with .375" x 1.5" Grade 8 bolts, nuts and washers. This configuration is designed to reduce body damage by directing impact under the body and away from the patient area should a rear impact crash occur. The center section of the bumper shall be 7" x 46" x 2" and be constructed of an open grate diamond back material and shall flip -up over center to facilitate loading a cot. The aluminum step shall be bolted to the sub -frame with 250" x 20 stainless steel bolts for ease of replacement. Y t/N 7.21.1 The removable end pods of'the bumper are constructed of cast aluminum. The height of the end pods shall be 4" and shall have 3" radius corners. The surface of the end pods shall be finished with 375" slip resistant raised pattern and embossed logo. Y_k/N 7.22 DOCK BUMPERS Two (2) rubber dock bumpers shall be provided and installed on the rear of the vehicle, to cushion the vehicle against impact. These dock bumpers shall be in addition to, the specified rear bumper. Y_ZN 7,22.1 An aluminum diamond plate protection plate on the rear face above the rear step shall be provided and T'IG welded to ensure secure fit. Rear kick plate shall not be screwed on or pop riveted. M