Laserfiche WebLink
Y—ZN <br />7.13 OXYGEN TANK MOUNT <br />One fully adjustable oxygen tank mount shall be installed in the exterior compartment <br />D1. This mount shall accommodate an "M" type oxygen tank. This oxygen tank <br />retention system must meet or exceed AMD Standard 003, Oxygen Retention <br />System. ® <br />Y ✓N <br />7,131 One (1) fixed shelf shall be provided in the D1 compartment located above the <br />oxygen tank. ® <br />Y �f N <br />7,13.2 Two (2) Model # 166AH Gear Hooks shall be mounted one (1) on the forward <br />wall and one (1) on the rear wall of the D1 compartment. Exact hook placement <br />shall be determined at the pre -build meeting. <br />Y_A/N� <br />7,14 ADJUSTABLE SHELVES <br />One (1) adjustable shelf will be provided and installed in the D-2 compartment. Each <br />shall be easily adjusted to accommodate equipment/supply requirements. <br />Y_V�__ <br />7.14.1 Two (2) adjustable shelves shall be provided in the D4 compartment. They <br />shall be easily adjusted to accommodate equipment/supply requirements. Y_VIN_ <br />7.14.2 One (1) adjustable shelf shall be provided in P-5 compartment fore of the <br />back board divider. <br />Y N <br />7.15 BACKBOARD DIVIDER <br />One (1) vertical, 55" x 17.5"x .125" smooth aluminum backboard divider shall be <br />through the inboard wall of Compartment P-5. It shall be positioned vertically 10" <br />forward of the rear wall. To provide protection for the equipment retained in the <br />compartment, the divider shall be Line-X coated. <br />Y_z6:_ <br />7.16 SCBA MOUNTING PLATE <br />The mounting plate shall be 24" high and run the full width of the compartment. The <br />mounting plate shall be made of 3116" smooth aluminum with rolled top and edges <br />and have a 314" lip. There shall be a 1" x 2" aluminum tube welded to the back of the <br />SCBA plate and mounted to the lower rear wall of the D4 compartment. <br />Y-0____ <br />7.17 EQUIPMENT RETAINERS <br />Three (3) seatbelt style retainer straps shall be provided and installed in the P5 <br />exterior compartment. One (1) shall be located in the aft section 40" from the floor <br />and two (2) located in the fore section 17" and 54" from the floor. <br />Y_Z�_ <br />7,17.1 A slide out stair chair holder for a Stryker model # 6252 stair chair shall be provided in the aft <br />section of the P5 compartment under the adjustable shelf. The holder shall be constructed of .125" <br />smooth aluminum with the entire holder covered with black Line-X bed -liner type material. The back shall <br />be 38" high, the front shall be at a slight outward angle and be 27" high. It shall be 22" wide and 9" deep. <br />43 <br />