Opening of Bids - Spec S - One or More 2018 or Newer Emergency Medical Vehicle - Horton Emergency Vehicle - Part 2

Home Browse Search

in the upper section of the ALS cabinet. Y�N_ 3.12 115 VOLT AC POWER There shall be 115 volt AC wiring furnished. A three -wire system is used for powering medical equipment, battery charger, etc. This electrical system, including wiring and associated equipment, shall comply with AMD STD 009, 120V AC Electrical Systems. The system shall incorporate a hospital grade GFI (Ground Fault Interrupt) device with a 20 amp circuit breaker that can also be used as a disconnect switch for the interior 116 volt outlets. The GFI device shall be located on the street side in the action area. When an inverter is specified, an automatic transfer switch shall be furnished which will automatically turn off the inverter 115 volt supply when the 115 volt utility shoreline power is applied. 3.13 INVERTER A Vanner, model 420-1050CUL inverter shall be provided and installed. The Vanner 20-1050CUL/CULW AC Power System shall combine a powerful DC to AC power inverter with an automatic battery charger/conditioner and a 30-amp AC transfer switch. When connected to shore power (AC utility power) the vehicle's battery is charged, than automatically maintained in full charge condition. The shore power shall be automatically connected to the system's AC output receptacle to supply power to the AC loads. When shore power is disconnected, (vehicle underway) the automatic transfer switch shall connect the AC output receptacle to the power inverter, which obtains power from the 12 volt battery. The 20-1050CUUCULW system shall contain a front panel LED indicator status panel and interface connector for the remote monitor/control unit. The inverter shall be mounted in the lower forward corner of the D2 compartment. ® Y ✓N 3,14 EXTERIOR SNORE POWER There shall be a Kussmaul 115 volt "Auto -Eject" plug rated at 20 amps or more with a spring -loaded cover assembly, UL listed for exterior use, located on the left side of the ambulance body close to the driver's door. The plug shall be equipped with a Dynamic Disconnect Switch. This shall energize the vehicle's 115 volt AC circuit from an exterior power source. This connector must be labeled: "115 volt AC, 60 Hz, 20 amp power supply". 3.15 INTERIOR 115 VOLT AC OUTLETS There shall be three (3) three -wire duplex 115-volt AC hospital grade receptacles. There shall be one [1] in the primary action area, one [1] in the second action area and one [1] in the ALS cabinet. There shall be red indicator lights located within each 115-volt outlet to indicate a live "hot" circuit. Add -on style indicators are not acceptable. The receptacles shall be clearly labeled: "115 VAC". Y,v 3.15.1 Two (2) additional three -wire duplex 115-volt AC hospital grade receptacles shall also be provided and installed. The one (1) shall be located over the squad bench and one (1) in the lower ALS cabinet. There shall be red indicator lights located within the 115-volt outlet to indicate a live "hot" circuit. It shall be clearly labeled: 115 VAC". YZN� 29