Professional Services Agreement - Black and Veatch Corp - Services for WWTP Electrical Upgrades

Home Browse Search

Task 102 — Basis of Design Memorandum A Basis of Design Memorandum (BDM) will be prepared to provide design information and project direction. The BDM will establish design criteria, project design schedule, project sequencing plan, control descriptions, and other important project design information. Five copies of the Draft BDM will be provided to the Owner for review prior as a separate deliverable to finalize design criteria prior to moving forward with design. The Owner's comments will be incorporated and five copies and one electronic copy in PDF format of the Final BDM will be submitted Task 103 — Solar Energy Study Engineer will review site information and documentation of available rooftops and other potential locations for installation of solar arrays. Upon completion of the workshop and review of the site, a Solar Energy Summary Technical Memorandum will be written to document input obtained during the workshop along with findings from review of available site information. This memorandum will include identification of up to three areas of the facility to target for further development of estimated costs and energy savings evaluations using photovoltaic solar array technology. Five copies of the Draft Solar Energy Summary Technical Memorandum will be provided to the Owner for review. The Owner's comments will be incorporated and five copies and one electronic copy in PDF format of the Final Solar Energy Summary Technical Memorandum will be submitted. Task 104 — Design and Contract Document Development The Engineer will prepare Contract Documents consisting of drawings and specifications to incorporate a total of three low -voltage switchgear lineups, four generators, seven MCCs, a 480V panelboard, and the Compressor Building Network Panel at the Wastewater Treatment Plant as well as demolition of the existing electrical gear, power cable, and conduit. The documents will be prepared for the selection of a private construction contractor on a competitive bid basis. One contract will be prepared for the performance of all work, including procurement of equipment. The Engineer's Standard Documents will be used for preparation of technical specifications and C-700 Standard General Conditions 2013 Edition will be used for the front end documents. The Components of the design include installation of two low -voltage switchgear lineups equipped with drawout power circuit breakers installed in the following locations: • Southeast Switchgear located in the Maintenance Shop appended to the north side of the Compressor Building • Northeast Switchgear located on the Operating Level of the Reuse Building Standby generators will be installed outdoors, adjacent to each of the above mentioned locations. A third generator will be located east of Gallery No, 4. The design shall also include installation of new MCCs to replace the existing outdated equipment located in the following buildings: Page 2 (Exhibit A — Engineer's Services) EJCDC E-500 Agreement Between Owner and Engineer for Professional Services Copyright 0 2008 National Society of Professional Engineers for EJCDC. All rights reserved.