Laserfiche WebLink
Positioning the cable clamp <br />1. Pull on the cable of the Cable management system to <br />hold the cable clamp in your hand. <br />2. Remove Torx screws. <br />3. Determine where to position the charging station cable <br />clamp. <br />Recommendation: The cable portion between the clamp <br />and the charging connector must not touch the ground when <br />the Cable management system is completely retracted. The <br />cable should hang about 2.5 in above the ground. <br />4. Apply the self-adhesive rubber band around the cable for <br />protection purposes. Set the clamp over the band and <br />reinsert the screws in it by adjusting the torque of your <br />tool to 7 in -lb. <br />5. Let the cable retract itself. Verify the clearing between <br />the charging station cable and the ground. <br />6. Roll the cable overhang around the charging station <br />cable holder. <br />EO <br />P <br />a <br />0 <br />CoRe+'M 15 <br />Cable management system and pedestal installation guide <br />