Laserfiche WebLink
The entire surface shall be cleaned again with certified wax and grease remover <br />before application of any primers. A self -etching primer shall be applied to provide a <br />base for adequate adherence of materials to be applied in subsequent steps of this <br />process. A high -quality urethane primer surfacer shall then be applied. The entire <br />surface to receive topcoat will be sanded smooth to ensure a level and defect free <br />surface. <br />Door edges and doorjambs shall be prepared similarly to other body surfaces and <br />finish painted with a certified topcoat paint. The entire surface of vehicle body shall <br />be DA finish sanded with no coarser than 320 grit dry sandpaper. The surface shall <br />be washed and wiped once again with certified wax and grease remover and tacked <br />for application of urethane sealer. <br />A full wet coat of urethane primer sealer shall be applied and allowed to flash per <br />specifications. Basecoat color will be applied to ensure color correctness then clear <br />coated with a minimum of 2 full wet coats of qualified urethane clearcoat and baked <br />at 140 degrees for 30 minutes. <br />Surfaces to receive striping and graphics shall then be sanded with 800 grit dry <br />sandpaper and masked off for application of additional color(s). Basecoat color shall <br />be applied to stripe and graphic areas until color is correct. Entire sanded surface <br />shall then be unmasked, inspected, and receive a minimum of 2 full wet coats of <br />certified urethane clearcoat. Topcoat will be baked again at 140 degrees for 30 <br />minutes. <br />Body is then color sanded, compounded, buffed, and polished to a smooth defect <br />free finish. <br />Upon final assembly, door hinges, hinge side of doorjambs and all stainless -steel <br />mounting hardware shall be coated with ECK, a corrosion inhibitor and permanently <br />mounted to vehicle. <br />Y N <br />25.2 BODY PAINT COLOR <br />The body shall be painted a single color of red with PPG base coat, clear coat paint <br />processes. Exact Color to be determined at pre -build <br />Y_N-A <br />25.3 ROOF PAINT COLOR <br />The roof shall be painted a single color of white with PPG base coat, clear coat paint <br />processes. <br />Y_ i N_ <br />25.4 SAFETY STRIPE <br />The body shall have a 2" wide reflective safety stripe around the entire perimeter <br />position above the main stripe. A QRS heartbeat shall be position on each side <br />towards the rear of the module. <br />YXN <br />25.5 REAR BARRICADE CHEVRON <br />There shall be 6" solid red 983-72 diamond grade reflective 60-degree stripes and 6" <br />fluorescent yellow green 983-23 diamond grade reflective stripes across the entire <br />