Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Horton Emergency Vehicles

Home Browse Search

Two (2) 5-pound rated ABC fire extinguishers with mounting brackets shall be furnished with the ambulance. These shall be shipped loose to allow the department to install in the desired locations. Y_N_ 24.9.1 Two (2) Two (2) Streamlight, model #SL-20-X handheld flashlights, each with charger base, shall be provided. Mounting location shall be one (1) on the driver side front console located directly behind the gear shift selector and one (1) located in the rearward ALS health center located halfway up. YXN_ 25.0 MODULE SURFACE PREPARATION A corrosion inhibitor shall be used on specified exterior surfaces and on specified fasteners, hinges and accessories that are subject to the effects of corrosion due to the electrolytic process that occurs between dissimilar metals. The product, designated as ECK, is a petroleum -based substance with a very slow rate of desiccation. The substance functions as a barrier to water, thus minimizing the electrolytic process. It shall be applied in the following conditions and to the following accessories and fasteners: 1. Behind stone guards or any other surface area where there is direct contact between dissimilar metals is direct contact between dissimilar metals. 2. On light assemblies utilizing self -tapping mounting screws that penetrate the body that penetrate the body. 3. On screws and screw holes for any accessory whose holes are drilled and tapped are drilled and tapped. 4. On the body surface when any accessory without a rubber or composite gasket is to be mounted (i.e. entry or compartment door hinges or light assemblies without gaskets) or composite gasket is to be mounted, i.e. entry or compartment door hinges or light assemblies without gaskets. ECK shall not be applied in the following conditions: 1. When mounting any accessory that has a rubber or composite gasket. 2. On light assemblies, which have plastic inserts for mount screws. Y_N 25.1 PAINT To produce a high -quality paint finish and to comply with the paint manufacturer's certification requirements for support of the warranty, the preparation and painting process described below must be used. Prior to initiating the surface preparation process, all hardware, handles, light fixtures, door hinges, corner trim, etc. shall be removed from the body. Additionally, any portion of the chassis, which does not require refinishing, shall be protected from the ensuing process. To rid the aluminum body of any extraneous materials or material impurities the entire surface shall be washed and wiped dry with a certified wax and grease remover. Excess weld material shall be removed by grinding all welds, seams, and any other body imperfections. The entire surface shall then be sanded with 80 - 150 grit dry sandpaper to provide good adhesion for any fillers and primers. The required areas will be filled with approved premium lightweight filler and sanded smooth. A premium polysurfacer will be applied directly over these areas to ensure adequate base for application of primers.