Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Crossroads Ambulance Sales & Service, LLC

Home Browse Search

2021 International MV/PL Custom Titan 170 Type I Ambulance Proposal Specification A5347-0002 11/05/20 17 CUSHION AND UPHOLSTERY FOAM PADDING: The foam padding on all head bumpers and upper padded surfaces shall be a Volara 2A, closed cell foam which is laminated and layered to a ½” thickness, to provide both compression resistance and compression density. This laminated, closed cell foam creates a padded surface that acts as an air-spring when compressed. This specialty foam naturally resists force and will not “bottom out” upon impact and provides positive resistance to pressures applied in any dimension, The foam padding on all side attendants, squad-bench seating and all seating backrests shall be a 3” Nimbus open cell foam with a # 1865 grade standard, which provides maximum rigidity while still maintaining comfortable seating upon a variety of weight compression. This grade of open cell foam allows the air to escape the foam under compression, thus providing a comfortable seating surface. Also, the density of the foam does not allow the foam to “bottom out” upon compression. The foam types used have low water absorption and vapor transmission rating and excellent thermal insulation and chemical resistant properties ADDITIONAL FOAM PADDED SURFACES: A 1/8” thickness of Volara 2A closed cell foam shall be applied to the radius area of the ceiling Heat and Air Conditioning duct work to provide a softer surface while enhancing the thermal properties of the heating and cooling system. The upholstered center section of the side and rear body entrance doors shall also include the 1/8” Volara 2A closed cell foam to provide a uniform appearance and a softer surface with an increase in thermal resistance. INSULATION ADDITIONAL RADIANT BARRIER, BODY INSULATION: The entire inside surface of the modular body, including walls and ceiling, shall be insulated with an additional aluminum faced radiant barrier insulation. This is to be installed in addition to the Thinsulate insulation to form an extra radiant barrier. The Thermal property of this combined (Thinsulate and Reflectix) insulation package is R 12.3. Areas behind heat generating light fixtures shall not be insulated. The insulation shall completely fill the voids between the frame members and the exterior skin. MODULAR BODY ENTRANCE DOOR INSULATION: All exterior patient compartment entrance doors shall be sound deadened with a composite acoustical sound deadening material. The internal skin surface of the interior door shall have this material bonded to it. The modular entrance doors shall have an additional thermal insulation of 2" thick "Thinsulate" bonded in place with clearance provided for door hardware. Interior door panels are provided with vibration isolators for the internal rods connecting the door handles to the latching mechanisms.