Laserfiche WebLink
9.0.1 THINLITE LIGHTS <br /> <br />Four (4) Trucklite model #80251C 18" LED panel lights, recessed into the ceiling <br />shall also be provided and installed. One (1) on/off position switch shall be provided <br />in the action area console. <br /> Y___N___ <br /> <br />9.0.2 An LED strip light shall be provided and installed in the primary action area. <br />This light shall have a manual "on/off" switch. Y___N___ <br /> <br />9.0.3 A rotary timer system shall be provided for the fluorescent lights. The system <br />shall be preset to automatically turn the lights off after activating. The timer shall be <br />from 5-60 minutes. <br /> <br />The patient compartment interior lights must meet the requirements set forth in AMD <br />Standard Test 016 Patient Compartment Lighting. <br /> Y___N___ <br />10.0 CEILING HEADLINER <br /> <br />The patient compartment headliner shall be constructed of a durable, high-gloss <br />white, plasticized Marlite, backed with a non-rigid non-wood material. The headliner <br />shall be securely affixed to the roof bows and to the .090” aluminum accessory plate <br />welded to the roof structure. There shall be a full-length inspection access/wire race <br />in the center of the ceiling, which provides access to the wiring harness and <br />antennae bases/leads. The access shall have removable padded vinyl covers. <br /> Y___N___ <br />10.1 FLOORING <br /> <br />A one-piece non-wood material sub-floor on all patient area floors less than 144" in <br />length shall be installed on top of the .090" thick aluminum sheet. The sub-floor shall <br />be securely fastened with sheet metal screws long enough to penetrate the 2" x 2" <br />body tubes below the .090" aluminum sheet. This process shall create a sandwich <br />effect for long lasting durability and a solid surface. All screws shall be filled and <br />sanded to provide a smooth surface for the linoleum covering. Floor lengths longer <br />than 144" shall include a two-piece plywood underlayment. Vinyl, anti-skid, <br />commercial grade, heavy-duty, non-porous floor covering shall be applied to the <br />entire floor in a one-piece seamless application. This commercial inlaid sheet vinyl <br />shall have minimums of nominal overall thickness of 2.03 mm. The flooring shall <br />comply with ASTM F 970 (modified) in regard to static load bearing and D-2047 <br />James Test for slip resistance. There shall be a 5" roll-up splashguard installed on <br />the street side cabinet wall and the squad bench face. A waterproof sealant shall be <br />applied between the cabinetry and the floor at the cabinet and floor covering <br />juncture. <br /> Y___N___ <br /> <br />10.2 REAR THRESHOLD <br /> <br />There shall be a 6" wide, 16 ga. formed, stainless steel threshold protector installed <br />on the rear interior of the body. The protector shall run the entire width of the floor at <br />the door opening. A 2" wide, adhesive-backed non-skid material shall be installed on <br />the threshold piece to assist with safe entry and exit from the vehicle. <br /> Y___N___ <br /> <br />10.3 INTERIOR PROTECTION