Laserfiche WebLink
<br />A fixed, privacy automotive glass window shall be provided a Cleer Vision Brand in <br />the right body side, above the rear wheel well in the upper body side. It shall be <br />approximately 36" wide x 18" high. <br /> Y___N___ <br /> <br />6.27 POCKET WHITEBOARD <br /> <br />A pocketed privacy slide shall be provided on the curbside wall. It shall be <br />incorporated into the side body window and shall slide into the wall rearward of the <br />window. When in use, the writing board shall cover the window. There will be a pad <br />covering the rear end of the privacy slide frame that the writing board will slide <br />behind. <br /> Y___N___ <br />7.0 EXTERIOR COMPARTMENT FABRICATION <br /> <br />All exterior compartments, excluding backboard compartments, shall be constructed <br />of .100" aluminum diamond plate walls and ceilings with .125" smooth aluminum <br />floors, formed and Heli arc welded. Exterior compartments are welded to both the <br />inside wall vertical structure and floor structure components for strength and <br />durability. Each floor shall be "sweep out" design. <br /> Y___N___ <br />7.0.1 All exterior compartment doors shall be equipped with a gas charged hold open <br />door check. <br /> Y___N___ <br /> <br />7.1 EXTERIOR COMPARTMENT DOORS <br /> <br />Each exterior compartment door shall be constructed of .125" aluminum sheet <br />double pan formed with a 1.5''' return bend with recessed offset supporting the .063" <br />3003 alloy aluminum diamond plate interior liner. Extruded doors and/or doorframes <br />are not acceptable. In addition, for maximum rigidity, 2.375" "C" channel bracing <br />shall be added internally for additional door structural integrity. The exterior face of <br />the door and the door edges shall be formed from one [1] sheet of aluminum. All <br />doors shall be flush with the body side and shall be fully insulated with polyurethane <br />spray foam. When opened, the doors will activate their respective compartment <br />lights. All compartment doors shall be keyed alike. Each access door is to be <br />stamped with an alphanumeric code; this will enable the quick and exact <br />replacement of a damaged door. The inner door panels shall be affixed to the flange <br />with stainless steel serrated spring washers and TX-25 Type F Torx-head machine <br />screws. <br /> Y___N___ <br />7.2 EXTERIOR COMPARTMENT DOOR HANDLES AND LATCHING <br /> <br />Door hinges shall be full length stainless steel #304-2B buffed and polished with a <br />1/4" stainless pin and shall be fastened to the door and door frame with self-locking <br />stainless-steel screws. Hinges are to be of a slotted style with a round hole on each <br />leaf of the hinge for permanent lifetime adjustment of the doors. Hinges shall be <br />staked, not welded, every 4” to prevent pin from moving. The locking mechanism <br />shall be a Tri-Mark #13136 outside handle, #13028 inside handle with a #12765-01 <br />gasket for the external handle with #14229-01 and #14230-01 rotary latch and <br />#10355U adjustable Nader pin. Latches shall be near flush with the door skin. Each <br />latch must be capable of being locked independently with an integral exterior key <br />lock and a key matching the locks on the curbside and rear entry doors. The latch <br />system is to be activated by the use of a .156” zinc plated steel rod with a single