Laserfiche WebLink
door pan flange to assure maximum sealing surface and to protect the rotary latching <br />mechanism from environmental influences. The inner door pan liner shall be affixed <br />to the flange with stainless steel serrated spring washers and TX-25 Type F Torx- <br />head machine screws. In addition, "C" channel bracing shall be added internally for <br />additional door structural integrity. <br /> <br />Both rear patient entrance doors shall have an FMVSS 206 tested Tri-Mark locking <br />handles keyed alike to the side entrance door and a Tri-Mark non-locking handle. <br />Each rear door shall have a two-point rotary latch with adjustable .50” Nader pins <br />with head flanges at the top and bottom with release handles on the interior faces of <br />the doors. When opened, the rear doors shall provide an opening of at least 63" <br />high and 54" wide. Each rear door shall be equipped with a Cast Products "grabber" <br />style door check, which shall be located at the bottom of the door. When opened, <br />the rear doors shall activate the interior dome lights and the rear exterior load lights. <br />Each access door is to be stamped with an alphanumeric code; this will enable the <br />quick and exact replacement of a damaged door. <br /> <br /> Y___N___ <br /> <br /> <br /> <br /> <br /> <br />6.22 DOOR TRIM <br /> <br />The door shall have a .090" aluminum panel covering the upper and lower door and <br />full width door panel with .028" Formica, with color to match interior and shall be <br />impervious to moisture, easily cleaned, durable, and attractive. The middle portion <br />shall be stainless steel and removable for ease of maintenance. <br /> Y___N___ <br /> <br />6.22.1 Each rear patient entrance door shall have a 1.5" diameter polished stainless <br />steel 90-degree ergonomic style assist handle. <br /> Y___N___ <br />6.23 REAR BODY CLOCK <br /> <br />One (1) MFS-121 Digital Atomic Clock (or equal) shall be provided directly above the <br />rear patient entrance doors, recessed into the center of the rear head pad. It shall <br />be wired directly to the vehicle electrical system. <br /> Y___N___ <br />6.24 SLIDING WINDOW <br /> <br />The entry/egress door shall be provided with a Cleer Vision Brand 20" wide x 19" <br />high horizontally sliding window. It shall have tempered automotive privacy safety <br />glass and shall have a locking mechanism to keep the window panels in the desired <br />position. A screen shall be provided, to prevent airborne particles from entering the <br />vehicle, when the window panels are in the open position. <br /> Y___N___ <br />6.25 FIXED WINDOWS <br /> <br />The rear patient entry doors shall each be provided with a Cleer Vision Brand 20" <br />wide x 19" high fixed window panel. Each window shall have tempered automotive <br />privacy safety glass. <br /> Y___N___ <br />6.26 SIDE BODY WINDOW