Laserfiche WebLink
American Response Vehicles <br />CLEAR COAT: The clear coat will be manufactured by the same company as the primer and base coat. Two coats <br />of "clear coat" polyurethane will be applied per the manufacturer's instructions. <br />3M POLISHING SYSTEM: Prior to 100% paint cure, the paint on the ambulance body will be sanded to 1200 grit <br />and polished flat per 3Ms Perfect -It product program for smooth finish. <br />CORROSION: Anti -electrolysis procedures include but are not limited to the following. <br />1) Ensure all bare substrate is dry and free from contamination. <br />2) If bare substrate is showing signs of corrosion/oxidation, sand and remove. Use 180 grit until area <br />is removed. <br />3) Thoroughly blow off areas to remove sand dust and metal shavings. <br />4) Thoroughly degrease to be pre -primed using the wipe -on, wipe -off method with clean white <br />rags. (Use good quality automotive Degreaser) <br />5) Apply Wash primer CR using a brush to all mated surfaces. Allow to flash for 15 minutes at 70 deg <br />Fah. Mix wash primer CR 1:1 with wash-hardner. <br />6) Apply Urethane caulk to all mated surfaces before assembly to reduce the possibility of corrosion. <br />EXTERIOR FASTENERS: All screw sites require a replaceable nylon insert for the fastener to thread into. This <br />will isolate the dissimilar metals. Each hole will be treated with an Electrolysis Corrosion Control compound <br />prior to installation of the nylon inserts. All exterior screws will be stainless steel. <br />PAINT WARRANTY: The conversion paint will be warranted to the original owner for a period of 7 years, 70,000 <br />miles. The color shift will be no greater than Delta E of 4.0 with minimum gloss retention of 60 gloss units at <br />twenty -degree angle. Warranty to include a 36-month Corrosion coverage with no exclusions. <br />UNDERCOATING: The bottoms side of the module will be undercoated, with an exception to any area <br />affected by exhaust system direct heat. Application standards for the undercoating will be achieved or <br />exceeded as directed by QVM or governing standards. <br />REFLECTIVE TAPE: The module door frames will have a three-quarter inch (3/4") wide white reflective tape <br />applied to the door frame interior. The tape will reflect direct light at night to illuminate the outline shape of <br />the door when the door is opened. <br />COMPARTMENT FINISH: Unless specified otherwise, all exterior compartment walls and backs will be <br />constructed of .100 polished aluminum diamond plate. <br />MAIN BODY COLOR: The main body color will be red, with the exact color code to be determined at a post - <br />award, pre -build conference. The paint finish will be laid onto the body in a flat, orange peel free, mirror like <br />shine on all four sides. <br />GRAPHICS PACKAGE: Graphics package will be installed to match the current fleet. Including but not limited to <br />custom tape belt, custom lettering, diamond grade chevrons on rear, including doors, and diamond grade <br />