Laserfiche WebLink
American Response Vehicles <br />CABINET "C": An interior cabinet will be provided at the rear end of the base cabinet on the street side. This <br />cabinet interior will be finished in high impact, white colored laminate. Must meet current Federal <br />specification KKK-A-1822. <br />DOUBLE HINGED SOLID LAMINATED DOORS: Two half inch thick flush fitted doors will be supplied on the <br />aforementioned cabinet. The doors will have a laminated with a color matching the agency chosen color face. <br />The interior color will be matte white. The spacing between the doors will be uniform and both doors will be <br />height aligned. The edges of the doors will be banded in durable aluminum trim to provide long lasting wear. <br />There is to be diamond plate backing on the side of the doors facing the exterior compartment. The doors are <br />to have non -locking round pull latches. <br />CABINET ACCESS: The above cabinet will be accessible through the inside and outside of the module. Exterior <br />Access will be made through the left rear compartment "M-3". <br />CABINET "D": An interior cabinet will be provided directly over the rearward "Telemetry Area just aft of the <br />CPR side seat within the base cabinet on the street side. This cabinet will be ergonomically angled towards <br />the CPR seat. This multipurpose cabinet interior will be finished in high impact, white colored laminate. The <br />cabinet will be ergonomically angled toward the CPR seat. Must meet current Federal specification KKK-A- <br />1822. This cabinet will have a sliding secure latch restocking window, top hinged. There will be (1) adjustable <br />shelf in this cabinet. <br />CABINET "F": An interior cabinet will be provided directly below the "Telemetry" Area. This multipurpose <br />cabinet interior will be finished in high impact, white colored laminate. Must meet current Federal <br />specification KKK-A-1822. This cabinet will have a bottom hinged lexan door, hinged with stainless steel <br />spring loaded style hinges. This door will feature a non -locking round pull latch. <br />CPR SEAT: A left side "CPR" side seat will be provided on the street side and aligned with the primary patient's <br />abdomen. The seat will be at least twenty four (24") inches wide and normal squad bench seat height. <br />Upholstered seat pads will be located within the seat area for the seat, back, both arms and hips. The CPR seat <br />area will have rounded corners. <br />BACK REST: The CPR side seat will feature a padded, fixed back rest with chamfered upper corners. <br />TELEMETRY AREA: A four inch wide upholstery covered and padded arm rest will be installed. The arm rest <br />will create a 3/4" to 1" lip on the leading edge of the telemetry area. <br />TELEMETRY AREA COUNTER SURFACE: The telemetry area counter surface will be made from one half inch <br />thick solid surfacing material. The color will complement the color scheme of the mica, floor, and upholstery <br />in the remaining areas of the vehicle interior. The material will be tested to the same material as the "Action <br />Area". <br />SOLID SURFACE COLOR: The color of the solid surface material specified above will be Northern <br />55 <br />