Laserfiche WebLink
American Response Vehicles <br />19 <br />ADJUSTABLE SHELVES: Two (2) standard duty aluminum adjustable shelves will be provided. The shelves will be <br />formed of .125 (1/8") thick aluminum, with 2 inch upward turned lips on all four sides of each shelf. <br />The shelves will be mounted on Unistrut infinitely adjustable, aluminum extruded, heavy duty shelf track. <br />Incrementally adjustable, non-aluminum shelf track is not acceptable. <br /> <br />ALUMINUM PLATE: This plate will be mounted on uni-strut infinitely adjustable brackets and will be located in <br />the bottom portion of the “M-3” Compartment. The plate will be made of 0.25 thick smooth aluminum sheet, <br />24” high, and should run the full width of the compartment. <br /> <br />COMPARTMENT LIGHTS: A total of three (3) lights will be mounted in the "M-3" compartment. All three lights <br />will be surface mount and will be LED. (1) light will be mounted on the compartment ceiling, (1) light will be <br />mounted on the bottom of each adjustable shelf. <br /> <br />ADDITIONAL COMPARTMENT LIGHT: (1) One light, in addition to standard light, will be mounted in the <br />compartment, per customer specified location. The light will be surface mount and will be LED. <br /> <br />RIGHT REAR COMPARTMENT (M-5): This compartment will be located in the right rear corner of the body. <br />The minimum compartment dimensions will be 84.5" High x 21" Wide x 22" Deep. <br /> <br />CEILING VENTILATION: Specified compartments will have a hat channel at the ceiling level. The hat channel <br />will run to no closer than 1" from the compartment side walls to allow for air exchange. Hidden from view, <br />will be two to three, (4") holes above the hat channel to exhaust the compartment air when the door is closed <br />to allow it to close with minimal effort. There will be additional horizontal square holes in the outward facing <br />vertical hat channel. <br /> <br />COMPARTMENT DOOR: A single, forward hinged, compartment door will be set for this compartment. The door <br />will have a single handle and two rotary latches. <br /> <br />DIVIDERS: One fixed divider will be formed of .125” thick 5052-H32 aluminum sheet. The divider will be sixty <br />inches (60") high by fourteen inches (14") deep: measured from the track: and have a two inch return flange <br />formed along the sixty inch edge for mounting. All corners on the dividers will be rounded or chamfered. The <br />exposed edges will be covered with automotive edge trim. Two full width, horizontally oriented, Unistrut C- <br />channel tracks will be fastened to the back wall of the aforementioned compartment. <br /> <br />ADJUSTABLE SHELF: A standard duty aluminum adjustable shelf will be provided. The shelf will be formed of <br />.125 (1/8") thick aluminum, with 2 inch upward turned lips on all four sides. The shelf will be mounted on <br />Unistrut infinitely adjustable, aluminum extruded heavy duty shelf track. Incrementally adjustable, non- <br />aluminum shelf track is not acceptable. <br /> <br />STAIR CHAIR ROLL OUT TRAY: A standard duty aluminum roll out tray will be provided. The tray body will be <br />formed of .125 inch thick aluminum sheet (5052-H34), with 3 inch upward turned lips. The tray will be brake <br />formed, designed to minimize weld length. The corners of the tray will be continuously welded. The slides will <br />be through bolted to the side of the tray body. The upper edge of the tray will have rubber coated Stampro