Opening of Bids - Seitz Park Reconstruction Phase I Proj No. 117-093A - Northern Indiana Construction Co., Inc.

Home Browse Search

the ladder rack. The pike pole is not on the apparatus as manufactured. The fire department shall provide mount the pike pole. 'IKE POLE 6 IT, PROVIDED BY FIRE DEPARTMENT NFPA 1901, 2009 edition, Section 5.8.3 requires one (1) 6 ft pike pole or plaster hook mounted to the ladder rack. The pike pole is not on the apparatus as manufactured. The fire department shall provide mount the pike pole. An Eberhard step or equal shall be provided on the driver's side front bulkhead. The step shall be a bright finished folding type. REAR FOLDING STEPS Bright finished, non-skid folding steps shall be provided at the rear. Each step shall incorporate an LED light to illuminate the stepping surface. The steps can be used as a hand hold with two openings wide enough for a gloved hand. Pump shall be a Waterous 5100/C20,1500 gpm single (1) stage rear mounted centrifugal type. No exceptions. Pump shall be the class "A" type. Pump shall deliver the percentage of rated discharge at pressures indicated below: - 100% of rated capacity at 150 psi netpump pressure. - 70% of rated capacity at 200 psi net pump pressure. - 50% of rated capacity at 250 psi net pump pressure. Pump body shall be close -grained gray iron, bronze fitted, and horizontally split in two (2) sections for easy removal of the entire impeller shaft assembly (including wear rings). Pump shall be designed for complete servicing from the bottom of the truck, without disturbing the pump setting or apparatus piping. Pump case halves shall be bolted together on a single horizontal face to minimize chance of leakage and facilitate ease of reassembly. No end flanges shall be used. Discharge manifold of the pump shall be cast as an integral part of the pump body assembly and shall provide a minimum of three (3) 3.50" openings forflexibility in providing various discharge outlets for maximum efficiency. The three (3) 3.50" openings shall be located as follows: one (1) outlet to the right of the pump, one (1) outlet to the left of the pump, and one (1) outlet directly on top of the discharge manifold. Impeller shaft shall be stainless steel, accurately ground to size. It shall be supported at each end by sealed, anti -friction ball bearings for rigid precise support. Impeller shall have flame plated hubs assuring maximum pump life and efficiency despite any presence of abrasive matter in the water supply. Bearings shall be protected from water and sediment by suitable stuffing boxes, flinger rings 56