Opening of Bids - Seitz Park Reconstruction Phase I Proj No. 117-093A - Northern Indiana Construction Co., Inc.

Home Browse Search

will also allow for compression to prevent water ingression. The doors shall be mounted in a one (1)-piece aluminum side frame with recessed side seals to minimize seal damage during equipment deployment. All seals including side frames, topes gutters and bottom panel are to be manufactured utilizing non -marring materials. Yl Bottom panel flange of roll -up door will be equipped with two (2) cut-outs to allow for easier access with gloved hands. A stainless -steel lift bar to be provided for opening the door and located at the bottom of YE)/NO each door with latches on the outer extrusion of the door frame. A ledge to be supplied over lift bar for additional area to aid in closing the door. The lift bar shall be located at the bottom of door with striker latches installed at the base of the side frames. Side frame mounted door strikers will include support beneath the stainless -steel lift bar to prevent door curtain bounce, improve bottom seal life expectancy and to avoid false door ajarsignals. All injection molded roll -up door wear components will be constructed of Type 6 nylon. Each roll -up door shall have a 3.00-inch diameter balancer/tensioner drum to assist in lifting the door. A garage door style shall not acceptable. YES O The header for the roll -up door assembly shall not exceed 4.00". A heavy-duty magnetic switch shall be used for control of open compartment door warning lights. )OOR GUARD There shall be five (5) compartment doors that shall include a guard/drip pan designed to protect the roll -up door from damage when in the retracted position and contain any water spray. The guard shall be fabricated from stainless steel or aluminum and installed on all ONO seven body compartment doors. MOUNTING TRACKS There shall be seven (7) sets of tracks for mounting shelf(s) in one in each body compartment. These tracks shall be installed vertically to support the adjustable shelf(s) and shall be full height of the compartment. The tracks shall be painted to match the ES O compartment interior. ADJUSTABLE SHELVES There shall be four (4) shelves with a capacity of 500 pounds provided. The shelf construction shall consist of. 188" aluminum with 2.00" sides. Each shelf shall be painted to ES O match the compartment interior. Each shelf shall be infinitely adjustable by means of a threaded fastener, which slides in a track. The shelves shall be held in place by stamped plated brackets and bolts. The location shall be determined at preconstruction. PULL-OUT TRAY There shall be three (3) slide -out trays with 2.00" sides and a capacity of 500 pounds �40 provided. Capacity rating shall be in the extended position. Slides shall be ball bearing type for ease of operation and years of dependable service. Automatic locks shall be provided for both the "in" and "out" positions. The trip mechanism for it shall be located at the front of the tray for ease of use with a gloved hand. 54