Laserfiche WebLink
4 <br />25 <br />0A <br />0 <br />9 8 44 <br />-. Attach upper and lower adjusting arms to top Pole tube #1. <br />9 8 (There are four flattened areas on tube #1 [See <br />6 7— Attach adjuster arms here.) Use bolts #35, washers #24, <br />� \ � nylon washers #30 (Put between adjusting arms and tube <br />Z7 <br />7-,m-.#VrSee 06'.11 and nut <br />11 <br />1 0 Itr-Q. (See Jell) Do not over- <br />tighten nuts. Arms must move easily. <br />28. Go back and tighten ALL LOOSE NUTS <br />snug. This i <br />cludes the nuts on the bolts #23 and #26 <br />that attach brace <br />tubes #22 to adjusting bracket (See sections <br />b) and on <br />bolts #18 that hold spacer plates #33 on <br />upper and lower <br />adjusting arms. (See section 6) <br />29 . Put Cap #4 on top end of tube #1. <br />Align the small oval holes in one end of to #2 with the <br />zz small square holes in the bottom end Of tube #1 and <br />slide <br />;=��tubes together. NOTE: Besure holes <br />a. <br />3 <br />are aligned. Thi <br />is A tight-fitting joint and you may not be able to Separate <br />tubes once they are together! - <br />_�:�__IIZ.Sdcure lube #2 to tube #1 with bolts #5 (insert bofts <br />#5 so <br />- thit their heads face the Eady Adjuster <br />unit), washers #7, <br />asl <br />-= hers *8, hex nuts #9, and acom nuts #6. Tighten <br />e. ruts tii* <br />-32.- Attach -the top Of backt)Oard #46 to brace <br />tubes #22 with <br />bolts #42, thick nylon spacers #29, washers <br />#44 and nu <br />#43. Tighten nuts tight. <br />33. Mount goal assembly and bottom of backboard ' <br />Z. <br />Z_ <br />#4 6 to <br />adjusting bracket with screws washers #44, lock- <br />washers #8, and nuts #9. Tight en nuts tight. <br />