Professional Services Agreement - DLZ Indiana LLC - Prep and Assistance with Fat Daddy's Demolition

Home Browse Search

d. Final Grading Requirements e. The Owner's preferences regarding recycling of materials f. Requirement regarding to isolate the building that houses Vicki's Bar from the building to be removed. g. Development of Bid Package and/or the Project Phasing requirements. One (1) Bid Package is anticipated as follows: 1) Abatement/Demolition Bid Package. c. Field Survey 1) Engineer will prepare a topographic survey for the project site based upon the chosen layout from the study report. All survey work for this project shall be performed in accordance with IAC Title 865 regarding Surveys in the State of Indiana. 2) Survey notice letters will be sent to property Owners whose property is within or adjoining the survey limits. 3) Control - Horizontal control will be based on GPS obtained Indiana East State Plane coordinates, NAD83. Approximately 3 control points will be set around the perimeter of the site. Vertical control will be based on GPS established NAVD88, unless otherwise specified by the client. Two temporary benchmarks will be set outside of the project limits for use by construction. All benchmarks will be thoroughly described and graphically shown on a control map. 4) Existing Right -of -Way and Property Lines - The Engineer will verify the existing right-of-way for all streets within the project limits. Subdivision plats, existing road plans, grant, deeds and other recorded documents pertaining to the right-of-way will be obtained from the St. Joseph County Recorder's Office. Field crews will search for existing right-of-way monuments, property irons and block comers; all monuments will be located. Field evidence and recorded documents will be analyzed to establish the existing right-of-way lines. All property lines and property Owner's names will be extracted from GIS data riles provided by the Owner. These lines will be combined with the existing right-of- way established by the Surveyor to create a final property map. 5) Full Topographic Mapping — Full topographic mapping within the limits shown in Exhitit A, Figure 1. a. Topographic survey data for both the planimetric map and the existing surface model will be collected for the project area. Shots to be taken for the planimetric map will include, but are not limited to, the following: edge of pavement, curb/gutter, drive entrances, sidewalk, vegetation, landscaping, known storm and sanitary sewer structures and known utilities (both visible on the surface and marked up underground). Shots to be taken for the existing surface model will include cross -sections every Page 3 (Exhibit A — Engineer's Services) EJCDC E-500 Agreement Between Owner and Engineer for Professional Services Copyright D 2008 National Society of Professional Engineers for EJCDC. All rights reserved.