Laserfiche WebLink
2019 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br />,41111 RIDE LOWERING SWITCH: <br />If the vehicle is Air -Ride equipped, the air suspension system shall be capable of lowering the height of the rear floor by <br />the use of an electric dump solenoid. The solenoid shall be activated when the left rear door is opened. An on/off <br />override switch shall be located just inside the left rear door to control the function of the air ride dump with the door. The <br />air suspension shall rise to the ride position when the door is closed regardless of the switch position. If the electrical <br />system is digital switching the switch will be one touch on/off. <br />CARBON MONOXIDE MONITOR: <br />A surface mounted Carbon Monoxide detector with audible and visual alarms shall be provided in patient compartment. <br />Detector shall be powered by 12 volt DC. <br />12 VOLT HOT UTILITY POWER LEAD. <br />The vehicle shall be pre -wired with a 12 volt HOT power lead terminating inside the front Cab console. The wiring shall be <br />12AWG, and include a power and ground conductor encased in loom. The ends shall be capped, and the circuit labeled. <br />12 VOLT HOT UTILITY POWER LEAD: <br />The vehicle shall be pre -wired with a 12 volt HOT power lead terminating within the Electrical Cabinet. The wiring shall be <br />12AWG, and include a power and ground conductor encased in loom. The ends shall be capped, and the circuit labeled. <br />12 VOLT HOT UTILITY POWER LEAD: <br />ne vehicle shall have a 12 volt battery hot, circuitry protected power lead supplied for the Knox MedVault. <br />INTERCOM SYSTEM PREWIRE: <br />An intercom system prewire shall be provided. The wire shall be a 22 gauge, shielded 9 wires. Extra service loops shall <br />be provided. The wire shall be ran as listed below: <br />(1) From front console to upper left of the walk through opening <br />(1) From front console to upper right of the walk through opening <br />(1) From front console to behind the LSS switch panel pod <br />(1) From LSS switch panel pod to the upper forward upper right side cabinet, behind the radio cut-out area <br />(3) From front console to the upper forward right side cabinet, behind the radio cut-out area <br />115 VOLT AC ELECTRICAL: <br />The vehicle shall include a 116 volt AC Electrical system separate and distinct from the vehicles 12 volt electrical system. <br />The entire system shall be designed and tested to meet the requirements of the NFPA National Electrical Code (NEC) <br />where applicable and use the balance of the NEC for general practices and procedures associated with high voltage <br />116/230 volt AC Electrical wiring and devices. <br />The vehicle shall also meet and be tested to all requirements of AMD standard 009. Test Documentation and verification <br />shall be provided upon request. <br />A4539-0001 <br />08/24/18 <br />48 <br />