Laserfiche WebLink
2019 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br />RADIO POWER LEADS: <br />An 8 gauge constant power positive lead and 8 gauge ground shall be provided with 40 amp circuit protection located <br />under the front cab console, <br />RADIO POWER LEADS: <br />An 8 gauge constant power positive lead and 8 gauge ground shall be provided with 40 amp circuit protection located in <br />the right side forward cabinet area, behind the radio cut-out. <br />12 VOLT ELECTRICAL EQUIPMENT <br />REAR STEREO SPEAKERS: <br />Two (2) low profile, flush mounted, AM -FM Stereo Radio Speakers shall be installed in the ceiling in the forward portion of <br />the vehicle. The speakers shall be spaced with other equipment provided, (1) each side. The speakers shall be <br />connected to the stereo radio within the cab dashboard. A "Volume Control" rheostat shall be provided in the rear switch <br />panel to allow speakers to operate independent of front speakers. <br />PREWIRED STREAM-LITE LIGHT BOXES: <br />The vehicle shall be pre -wired for two (2) hand-held portable lights as listed below. The light boxes shall be tied to the 12 <br />volt constant circuit located within the vehicle. The 12 volt circuit shall be properly labeled and circuit breaker protected at <br />'he battery source. <br />- (1) Forward area of the driver side front console <br />- (1) Right side walk through area <br />STREAMLITE RECHARGEABLE& <br />Two (2) Streamlite SL-20X, Rechargeable, lights shall be provided and installed within the vehicle as listed below. The <br />lights shall be tied to the 12 volt constant circuit located within the vehicle. The 12 volt circuit shall be properly labeled <br />and circuit breaker protected at the battery source. The lights shall deliver up to 30,000 Candlepower, <br />(1) Forward area of the driver side front console <br />(1) Right side walk through area <br />INTELLITEC CLOCK WISWEEP SECOND HAND; <br />An Intellitec digital clock with sweep second hand and elapsed timer shall be installed on the face of the angled 45 degree <br />cabinet above the LSS; area. The clock shall be powered by a constant, protected, 12 volt source directly from the <br />batteries. <br />The clock shall have a 4-digit display to allow for easy viewing when seated in any position in the rear of the ambulance. <br />The clock is 6.75 x 4.75 x 1.25 mounted in a 6" x 5" panel cut out using 4 screws. <br />A4539-0001 <br />08124/18 <br />47 <br />