Laserfiche WebLink
2019 International MV/PL Custom Titan 170 <br />Type I Ambulance Proposal Specification <br />12 VOLT UTILITY AND MEDICAL OUTLETS <br />12 VOLT MEDICAL OUTLET: <br />One (1) 12 volt Power Point outlet shall be provided. The outlet shall be circuit breaker protected and provide a source <br />directly from the vehicle batteries, and bypass the vehicles master battery disconnect switch. The outlet shall be <br />located at the Life Support Station. <br />12 VOLT MEDICAL OUTLET: <br />One (1) 12 volt Power Point outlet shall be provided. The outlet shall be circuit breaker protected and provide a source <br />directly from the vehicle batteries, and bypass the vehicles master battery disconnect switch. The outlet shall be <br />located in the right front inlout access compartment. <br />MEDICAL EQUIPMENT ISOLATOR: <br />Per the requirements of KKK-A-1822, a low voltage drop, Shottky, Medical Isolator shall be installed to protect the medical <br />equipment from loads imposed by the vehicle. Only heat sink mounted isolators shall be used. The use of medical <br />isolators built into P.C. board type electrical systems, is an unacceptable substitution. (No Exceptions) P.C. Board or <br />permanent type may require replacement of entire board to repair a problem with this medical equipment circuit, <br />ANTENNA AND COMMUNICATION RADIO EQUIPMENT <br />ANTENNA: <br />A Coaxial Antenna lead shall be prewired from a location in the wire raceway to the location of the two-way <br />communication radios. <br />The antenna lead in the roof shall include a connector soldered to end of cable for install of two-way communication radio <br />antenna. <br />ANTENNA LEADS: <br />Three (3) coaxial cable antenna leads shall be installed; they shall be positioned within the body roof, in numerical order, <br />as indicated by the associated PDF picture file. They shall terminate in the following location(s); <br />- Front Console <br />- Behind Driver Seat <br />- Right Side Upper forward Cabinet Area behind Radio Cut-out <br />RADIO POWER LEAD; <br />A 10 gauge constant power positive lead and 10 gauge ground shall be provided with 30 amp circuit protection located in <br />the Rear Main Switch Panel. <br />RADIO POWER LEADS: <br />A 10 gauge constant power positive lead and 10 gauge ground shall be provided with 30 amp circuit protection located <br />under the front cab console. <br />A4539-0001 <br />08/24/18 <br />46 <br />