Opening of Bids - Spec S - One or More 2018 or Newer Emergency Medical Vehicle - Crossroads Ambulance Sales & Service LLC - Part 2

Home Browse Search

2019 International MV/PL Custom Titan 170 Type I Ambulance Proposal Specification 12V AIR CONDITIONING CONDENSER: The vehicle shall be equipped with a body 12 volt air conditioning condenser. The air conditioning condenser shall be added to provide refrigerant cooling for the auxiliary compressor added for the body. The condenser shall be fan cooled by a condenser mounted 12 volt cooling fan. The fan shall be relay controlled and only be activated when the rear air conditioner unit is activated. The cooling rating of the condenser shall be 40,000 BTU, and the air flow rate shall be 2,800 CFM. DUCTED HEATER AND AIR CONDITIONING SYSTEM: The unit shall have a minimum capacity of 38,000 BTU Air Conditioner and 60,000 BTU Heat operating with 12 volt power, The unit will have a high performance 650 CFM Brushless blower fan with a five (5) year warranty. A receiver - dryer shall also be installed on the evaporator case to remove moisture from the refrigerant system. The climate control unit shall be permanently attached to the double ductwork system running full length of the ceiling of the vehicle. Each duct shall be fully contoured with approximate dimensions of 5" wide and not protrude more than 2 3/4" from the ceiling. In addition each duct shall have four (4) equally spaced from front to rear, fully adjustable 4-way adjustable louvers with shut off feature at each register. The duct work shall be covered with a fully padded vinyl covering and incorporate the vehicles drop down wire raceway cover in the center. The heater/air conditioner unit shall be located in the front of the vehicle centered above the cab to body pass through. An air cleaner filter shall be installed in the return air grille located in the underside of the cabinet. The climate control unit shall include a twin air return system. One mounted high and one mounted low for full air re- circulation. In addition the entire climate control unit shall be double insulated first by the standard body insulation and secondly by a fully encompassing 5/16" thick reflective insulation. The reflective insulation shall also extend the full length of the raceway duct, front wall and ceiling of the climate control cabinet. All heater hoses provided shall be OEM style EPDM rubber type. The use of lesser quality hose or silicone hose is an unacceptable substitution. The systems heater shall include an electric 2-way, internally piloted, normally closed solenoid valve which only opens when the heater unit is "On" and when the vehicle is running, The heater shut off valve shall also include an emergency shut off switch located within the rear power distribution panel. All Air Conditioner hoses shall be Goodyear Galaxy Type 4890. Barrier type hose shall be unacceptable. No exceptions or deviations to this system will be allowed due to its superior air distribution system and low noise characteristics. An exception will be cause for rejection of bid. Bidderlmanufacturer must provide proof that this is an operating climate control system, offered as a standard component in their emergency vehicle production. Prototype systems are not acceptable, A user list of vehicles utilizing this system shall be provided with the bid. ELECTRONIC DIGITAL DISPLAY THERMOSTAT CONTROL: A digital electronic Climate Control thermostat shall be used to monitor and control both air conditioning and heating in the rear patient compartment. The following features are included: A 1/2" backlit digital display, which displays both ambient and set temperatures. Ambient readout is displayed by default. Temperature adjustment is 500 F to 990 F or 100 C to 370 C, Seven (7) fan speeds standard. Three (3) and Five (5) speed options also available. The fan speed is easily controlled by using the color coded tactile up or down arrows. A4539-0001 08/24/18 43