Laserfiche WebLink
* Loader bucket dump time shall be no more than 3.0 seconds at full raised position. <br />Loader bucket shall be self -leveling for truck loading spoil and equipped with a bucket tilt <br />indicator. <br />Loader bucket lower time from fall raised position to digging position shall be no more than <br />3.0 seconds. <br />* Loader bucket raise time to full height shall be no more than 4,0 seconds. <br />WORK TOOL OPTIONS <br />The OEM shall offer buckets in varying widths and capacities. <br />Buckets shall be equipped with pin -on tooth tips that are exchanged whereby the pin <br />retainers are diagonal or vertical, allowing them to be extracted or inserted with a hammer <br />and punch only. <br />A quick coupler system shall be available (mechanical and hydraulic), which will pick up the <br />'direct mounted' worktools. <br />All backhoe sticks shall be made thumb -ready, allowing bolt -on installation of thumbs, <br />cylinder, hydraulics and hardware without welding. <br />SERVICEABILITY <br />Hood release to be lockable and easily accessible from inside the cab. <br />Engine oil, transmission oil, hydraulic oil, brake fluid, washer fluid, coolant, engine air filter, <br />and engine air filter monitor shall all be consolidated service points, accessible under the <br />hood with loader arms down. <br />Entire machine cooling package, including radiator, transmission oil cooler, hydraulic oil <br />cooler, fuel cooler and ATAAC shall be easily accessible without use of tools. <br />Water and sediment shall be drained from the fuel / water filter from a standing position <br />without tools. <br />The battery(ies) shall be accessible without the use of hand tools to remove panels, <br />toolboxes, etc. <br />Unit shall come standard with machine jump posts <br />The swing frame shall have replaceable bushings installed in the pin joints for the boom, <br />swing cylinder rod ends and swing post. <br />Swing cast shall utilize serrated pins and dimpled bearings for grease rotation <br />Machine shall have easily accessible jumper posts to aid in jump-starting machine or other <br />machines. <br />The hydraulic tank shall be drained through a petcock and drain hose, without need for hand <br />tools. <br />* The rear axle shall have brake wear check ports, allowing access to inspect brake pad wear. <br />The machine will be equipped with an electronic diagnostic port within the operator station, <br />allowing service codes to be downloaded and electronic parameters to be adjusted. <br />* Fuel tank shall contain a debris screen <br />