Laserfiche WebLink
* Auxilary controls shall be controlled by a electro-hydraulic thumb roller <br />* Auto -up stabilizer controls shall be available. <br />Stabilizers shall be pilot operated for low efforts and located on the side console for easy <br />access whether facing front or rear. <br />* Stabilizer guards shall be available to protect stabilizer cylinders from damage <br />* Backhoe shall have stabilizer lock valves as standard equipment. <br />* Flip over stabilizer pads shall have a dirt grouser. <br />Stabilizer spread in the operating position to the center of the pad shall beat least 110,110" <br />(3310 mm). <br />Stabilizers shall be able to lift the machine high enough to clear tires, on concrete with street <br />pads. <br />* Swing trunnion shall be supported on each side by two bolts loaded in tension . <br />LOADER <br />* Loader bucket shall not roll back, and must not move under normal dig operations. <br />* Loader shall have positive down pressure sufficient to lift tractor front end off level ground. <br />1.31 CYD (1.00 m3) Multi Purpose bucket (4 in 1). Machine shall meet <br />specifications <br />Minimum breakout force of 11,020 lbs (49 kN) <br />Minimum dump clearance of 97' (2798 mm) at full lift and 44 degree discharge <br />Minimum dig depth of 4" (110 mm) <br />Minimum hinge pin height 11'5" (3474 mm) <br />Minimum lift capacity 6,828 lbs (3097 kg) <br />Minimum rackback angle at Ground Level of 38 degrees <br />Loader shall be equipped with a return -to -dig mechanism. <br />Loader shall be equipped with a lift cylinder brace to mechanically hold the loader arms in the <br />raised position. <br />Multi -Purpose bucket shall be operated by a thumb control on the loader joystick <br />Loader arm torque tube shall be constructed such that it is welded to each side of each <br />loader arm section, providing maximum strength with minimal weld stress. <br />Loader linkage shall incorporate a single, full width main tower pin for maximum strength and <br />load distribution. <br />Loader bucket shall be suitable for general purpose with heavy-duty characteristics including <br />high strength wear material in the leading edges of the lower side corners, equaling the <br />material properties of the base cutting edge. <br />Loader bucket base cutting edge shall be specially hardened steel, achieving Rockwell <br />hardness of 50 or greater. <br />Loader bucket shall have a 2-piece or 3-piece bolt -on cutting edge for serviceability. <br />