Laserfiche WebLink
SHALL BE <br />AS <br />TYPE DESCRIPTION SPECIFIED <br />(Circle One) <br />driver's side. <br />'Shovel Holders: Body shall include two hook mounted shovel holders located on the YES l NO <br />driver's side front body bulkhead. <br />"Undercoating: Due to the :aature of usage that this vehicle will be used in extreme <br />snow and ice applications the dump body shall have an Elastorneric <br />Polyurea Coating with an approved 7 year warranty applied under <br />the road side of the body floor ( Rhino lining, or spray on rock guard <br />will not be accepted). Data sheets of the material be bid shall be <br />included in the proposal. <br />Body Light -The dump body shall be ready to accept following light <br />Configuration: configuration and have the following light holes laser cut at the <br />body manufacture, <br />-6 Recessed laser cut oval holes facing forward in the body cab <br />shield. <br />-6 Recessed laser cut oval holes facing rearward in the body cab <br />shield. <br />-One Recessed laser cut oval hole per side facing each side in the <br />side of the body cab shield. <br />-One recessed laser cut oval hole per side racing each side of the <br />body mounted on the lower body rub rail. <br />-All strobe Iights small be boxed in on their back side. <br />Body rear post shall have a minimum of three laser out oval holes <br />per side. <br />:Hoist: -Shall be double acting underbody hoist. <br />--Hoist shall have an NTIA rating of Class 60. <br />-foist shall be rated to lift a maximum of 22 ton with 12" overhang. <br />-Hoist sub frame shall be '/4" and 50 ksi typical yield strength <br />fabricated steel Channel. <br />-Body shall have 12" of overhang behind the sub frame binge. <br />-Body shall obtain a 50 degree dump angle. <br />-Cylinder shall have an 8,00" bore axed a 20" stroke. <br />Cylinder piston shall be 3" diameter and 2" diameter pin -eye rod <br />end. <br />-Cylinder shall be capable of operating at work pressure of 2000 <br />psi. <br />-Hoist shal I incorporate a body prop and body up light. <br />-Unit shall be manufactured and assembled within conformance to <br />16 <br />DESNO <br />(Y)E,/ NO <br />DE-(/ NO <br />