Laserfiche WebLink
SHALL BE <br />AS <br />TYPE DESCRIPTION SPECIFIED <br />(Circle One) <br />along the floor, side wall, and Head Sheet to ease flow of material <br />when dumping and during clean -out procedures. Formed, radius, or <br />integrated cleanouts are not acceptable. <br />Tailgate: <br />-Chains shall be encased in chain mesh material as to not scratch <br />YES NO <br />the body. <br />-Tailgate shall be air operated with a 3 1/2" x 8' it cylinder <br />V4 CA K� <br />mounted center of the body. A forward mounted air cy ender will <br />S TYL- <br />not be accepted. Latch must loch over center when tailgate is <br />closed and maintain adjustability throughout operating life. <br />-Top Cap of the tailgate shall have a 45 degree sloped top to shed <br />material. <br />-Top Cap of tailgate shall be fully boxed. <br />-Tailgate sliall have two lift rings attached near top. <br />-Tailgate shall have internal 2 x 2 x 3/8 angle steel at floor level to <br />prevent crushing. <br />Cab Shield: <br />-Cab Shield: Shall be 7 Ga. 304Qigh strength stainless steel Cab -"'?-YES / NO <br />Shield shall be integral to the body and shall be installed at the <br />factory as part of the body for added strength as well as to prevent <br />weld runs. <br />-Shall project forward 27" and be full width of side walls shall be <br />attached by welding. <br />-Forward projection shall have a 5-degree slope. <br />-Cab Shield height shall be 76" fi-om the chassis frame (to be <br />confirmed by purchaser prior to body fabrication). <br />Stone Apron: <br />Body shall include a 10" stainless steel stone apron (spill shield). <br />YE, / NO <br />Apron shall be pin on and shall interchange with the tailgate <br />spreader. <br />Ladder/Steps: <br />-Ladder shall consist of three to four safety laser cut tread bed entry <br />DYES/ NO <br />steps mounted on the driver's side front of dump bed. There shall <br />also be a pull out drop down ladder mounted under the dump bed to <br />access the entry steps. There shall be a minimurn of one inside <br />safety tread mounted on the inside of the dump bed from driver's <br />corner for access from inside the body to outside. Ladder and steps <br />shall be constructed of 7 gauge 304 stainless steel. Ladder and <br />steps shall include a grab assist handle located on the outside of the <br />body full length of the steps. <br />-There shall be a grab/grip handle inside the front of body on the <br />15 <br />