Laserfiche WebLink
SHALL BE <br />AS <br />TYPE DESCMPTION SPECIFIED <br />(Circle One) <br />220,000 lbs. No substitutions regarding thickness and material will <br />be accepted. <br />-All welds shall be continuous. <br />-There shall be (two per side) board brackets to accept 2" x 8" side <br />boards. <br />-Lower side Rub Rail shall have 45 degree material shedding slope <br />in order to avoid roads Insh and to lower the bodie <br />chassis tires, the hall drop a minimum of 3" lower than �' `"t T <br />the floor. <br />-Top Rail shall be fully boxed. <br />-Rear Bolster Panel shall be full width. <br />-Rear Corner Posts are box formed with 45 degree leading edge. <br />-Rear Corner Posts shall have material shedding sloped top cap. <br />-Rear Corner Posts shall have three (3) OEM laser cut ovals for <br />light placement. <br />-Rear Corner Posts of the body shall be shielded from underneath, <br />in order to prevent snow, ice, and debris buildup. <br />-door unde:rstixicture: Shall be a fabricated "crossmember-less" <br />design wit a ezoidal maximum Lang Sills. - AM <br />-Long Sills shall be fabricated from 3/16" 50 ksi typical yield <br />strength steel. <br />-Long Sills to contain 3/16" 50 ksi internal gussets spaced 24" on <br />center and 3 gussets clustered at rear hinge attachment location. <br />-"The dump body shall have a sealed tube running from the rear of <br />the body to the front to allow light wires to be enclosed. <br />-Tailgate shall be double acting 6 panel: tailgate shall have the <br />ability to dump conventionally and the ability to lay flat (level with <br />floor) with adequate Iength 3/8" high strength chains. _c� -Tailgate hardware (tailgate hinge, hinge boa, and latch) shall be 1" <br />cast ste both upper and lower. `l`ailgate shall utilize an offset <br />upper extended tailgate hinge forward approximately 7" to facilitate <br />controlled dumping. Tailgate and all horizontal members shall have <br />45 degree sloped top to shed material. <br />-1-3/4" thick upper tailgate hinges shall have 1-1/4" pivot phis with <br />zerk Lubricat ion. <br />-Two sets of laser cut banjo plates and with adequate length 3/8" <br />high strength chains to hold tailgate in the down position shall be <br />provided. <br />-Bulkhead (Head Sheet) shall be 7 gauge 3040tainless steel. 'IzZ <br />-There shall be a 45-degree cleanout plate welded inside the body <br />14 <br />