Laserfiche WebLink
<br />Mule-Hide Products Co., Inc. Page 2 of 3 PDS 09-1305 <br />Product Data Sheet <br />MULE-HIDE STANDARD BLACK EPDM MEMBRANE <br /> <br />SPECIFICATIONS (continued) <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br />PACKAGING <br /> <br />Standard Black EPDM (with and with-out tape) are available in a variety of sizes with widths up to 50’ and lengths <br />up to 150’ long. Contact Mule-Hide Products for specific rolls sizes available. <br /> <br />BENEFITS & SUPPLEMENTAL STATEMENTS <br /> <br /> Can be installed over a variety of roof decks <br /> Outstanding weatherability <br /> Sheets can be pre-taped for labor savings and consistent seam placement <br /> Requires no special equipment to install <br /> Available as a lightweight system <br /> Full line of pre-taped accessories available <br /> <br />CODE APPROVALS/COMPLIANCE <br /> <br />A variety of Factory Mutual Ratings, Underwriters Laboratories Classifications and Miami-Dade Approvals are <br />available. Contact Mule-Hide Warranty Department for additional information. Meets or exceeds requirements of <br />ASTM D 4637, Type I for non-reinforced EPDM single-ply roofing membranes. <br /> <br />INSTALLATION INSTRUCTIONS <br /> <br />1) Fully Adhered Roofing System <br /> a) Approved insulation shall be attached to the roof deck with an approved insulation adhesive or approved <br /> fasteners and plates. <br /> b) The field of the roof is fully adhered to the substrate with Mule-Hide membrane adhesive. <br />2) Ballasted Roofing System <br /> a) Approved insulation to be loosely laid to the deck. <br /> b) Roofing membrane is loosely laid over insulation and ballasted with washed river rock or pavers. <br />3) The membrane is required to be mechanically attached at the base of all vertical surfaces, roof edges, and <br /> angle changes greater than 2:12. <br />4) All seams are to be constructed with seam tape and tape primer, and checked for voids. <br />5) All details will be done in accordance with Mule-Hide details. <br />6) On projects where a Mule-Hide Standard or Premium Warranty is requested, an authorized Mule-Hide <br />representative shall inspect all completed work. This is only a brief summary and not the complete <br />specification. The Mule-Hide Specifications, Details, Technical Bulletins, and associated documents should <br />be thoroughly reviewed prior to starting any project. Contact Mule-Hide Products for additional information. <br /> <br /> <br />*Typical properties and characteristics are based on samples tested and are not guaranteed for all samples of this <br />product. This data and information is intended as a guide and does not reflect the specification range for any particular <br />property of this product. <br />**Not a Quality Control Test due to the time required for the test or the complexity of the test. However, all tests run <br />on a statistical basis to ensure overall long-term performance of the sheeting. <br />LEED Information <br />Pre-consumer Recycled Content 5% <br />Post-consumer Recycled Content 0% <br />Manufacturing Location Carlisle, PA or Greenville, IL <br />Solar Reflectance Index (SRI) 9