Laserfiche WebLink
minimum, sides and roof 8-gauge minimum abrasion resistant steel. Front <br />of body to have window covered by expanded metal. Body to include rear <br />view and hopper camera system. To include front and rear mud guards on <br />rear axles and rear mudguards on front axle. All roof and sidewall <br />members shall be continuously welded. <br />Hopper: All surfaces exposed to abrasion or wear in hopper must be Hardox 450 or <br />better. Floor and side walls to be 3/16 inch minimum. Front wall to be 12 <br />gauge minimum. Hopper to be completely enclosed with left hand door <br />equipped with lock to hold it open or closed. Door to be 14-gauge steel <br />minimum, left door 26" x 36" minimum. Hopper to include a 40-gallon <br />minimum leach aid tank with easily accessible drain valve. Work lights to <br />be included for the hopper. Hopper to also include crusher panel. <br />Fully Automated <br />Cart Lift <br />Mechanism <br />Right Side Automated cart lifting mechanism to be on the right side of the vehicle. <br />Mechanism to be equipped with a grab clamp using high friction rubber <br />pads or strapping to enable loading roll carts. Center of gripper is offset by <br />a maximum of 24" from the center of lift pivot point. Clamp to accept <br />carts from 32 gallon to 110 gallon without adjustments. Unit shall have a <br />minimum 0" to 120" horizontal reach from right side of vehicle. Unit <br />shall be capable of lifting 400 lbs. minimum, maintain self -leveling of bin <br />throughout the dump cycle. Unit to include control to automatically start <br />packing process after cart is dumped. Unit to include grabber work lights <br />and spill shield. All functions of the mechanism must operate at all engine <br />speeds including idle. Unit to incorporate switches with the joystick to <br />provide cushioning at the end of cylinder strokes. The joystick shall have <br />an off switch for control of the grab clamp. A lock valve shall be <br />integrated in the inner boom cylinder to prevent any movement of the arm <br />without actioning the joystick. Unit shall have secondary controls for the <br />arm. Due to the extra maintenance chain style cart lifts will not be <br />accepted. <br />Rear Tail Gate: To be 10-gauge minimum steel with two 2 %2" minimum operating <br />cylinders, automatic hydraulic locking mechanism and safety pin. Tail <br />gate to include a rubber seal on both sides and bottom to prevent liquid <br />leakage. Manual control valve with safety lock to be in the cab and to <br />include light and audible alarm when tail gate is unlocked. Tail gate to <br />include safety prop rod and hydraulic line flow restrictor to prevent <br />sudden descent. <br />Packer: Packer face plate and ram top thickness to be 1/4" AR-200 steel or equal. <br />Packer to be guided on structural tubing guide rails. Packer panel shall be <br />equipped with top, side and bottom wear bars. Bottom wear bars to be a <br />minimum 3/8". Packer to be operated by two double acting cylinders <br />