Laserfiche WebLink
Cab Shield: <br />Tailgate: <br />Telescopic <br />Hoist: <br />rail shall be 5-1/2" wide 35 degree slope outward for dirt shedding. <br />Grip strut walk bar shall be installed on both sides. Sides shall have <br />vertical postbox bracing. Top Rail shall be fully boxed Lower rub <br />rail shall be material shedding. <br />The body shall have a rear spreader apron 12" deep. Apron shall be <br />pin on type and shall be able to interchange with tailgate spreader. <br />There shall be (two per side) gussets to accept 2" x 8" side boards. <br />Cabshield shall be 24" full width and be constructed of 3/16 450 <br />Hardox. <br />Rear Pillar shall have three (4) ovals cut -in by the body <br />manufacturer for light placement. <br />There shall be a fold down ladder located on the dump body <br />mounted on the driver side front corner. Location shall be confirmed <br />at time of installation with purchaser. <br />There shall be a step type insert on the front driver's side on the <br />inside of the body. <br />Paint Body shall be painted to match the South Bend Water Works <br />body color. Bidder shall check on final color with the Fleet <br />Manager as to proper paint code. <br />Final paint shall be a baked on automotive finish. <br />Miscellaneous: There shall be installed a body prop, body up light, <br />back up alarm. <br />Body shall have 2 shovel brackets installed on the front of the body. <br />Cab protector shall be made from 8 gauge steel with 2" x 3" flat <br />steel reinforcement. <br />Tailgate shall be two formed panels will be single wall constructed <br />with'/4"" Hardox 450 and shall be double acting. <br />Tailgate chains shall be encased in chain mesh <br />Two sets of cast banjo plates and chains long enough to bold tailgate <br />in down position. <br />Rear Pillar shall have sloped top. Minimum 1" flame cut offset <br />upper tailgate hinge. Minimum 1-1/2" upper tailgate pin. <br />All welds shall be 100% continuous.. Minimum 1-1/4" lower tailgate <br />pin incorporated in lower vertical tailgate brace <br />Minimum 3/8" diameter proof coil spreader chains. Complete <br />tailgate latching assembly reinforced with a'/" backing plate for <br />added strength. Upper and lower banjo eyes in each rear corner post. <br />Air operated tailgate latch mechanism. <br />All tailgate pivots are grease zerk lubricated. <br />The hoist shall be of telescopic design and have a Trunion <br />mounting. <br />The hoist shall be double acting <br />The hoist shall be designed to operate up to 2,500 PSI, and shall be <br />self -bleeding. <br />15 <br />