Industrial Discharge Permit - St. Joseph Energy Center

Home Browse Search

The permittee shall measure and report the wastewater discharge flow for the duration of each sampling event. Totalized daily flows shall also be submitted with the Periodic Compliance Report (PCR). For batch discharges, the permittee shall report the date and the volume of each and every batch discharge. Each PCR shall include all flow measurements for the entire monitoring period covered in the report. 3. The permittee shall calibrate any flow measurement device as needed, but no less than once annually. The calibration shall be performed by a qualified individual, with the appropriate equipment, and by a method acceptable to the Control Authority. The permittee shall submit all records of calibration to the Control Authority. 4. Spare level sensing and totalizing/recording instrumentation, and sampling repair parts shall be available for immediate installation upon discovery that flow measurement devices are not operating properly, or as described in the FMP. 5. The permittee shall not, at any time, remove, alter, or change any of the flow measurement devices described in the FMP. Any proposed change to the FMP shall be submitted to the Control Authority for approval. If the permittee is unable to measure flow as described in the FMP, the permittee shall immediately notify the Control Authority. I. Reporting Information and Correspondence with the Permittee 1. Unless otherwise provided in this permit, all correspondence related to this wastewater discharge permit shall be sent to the Control Authority at this address: City of ,South Bend Division of Environmental Services Industrial Pretreatment Group 3113 Riverside Dr. South Bend IN 46628 2. In the event that an oral notification is required the permittee shall call 574-277-851 S and dial zero (0) to reach an operator. 3. All correspondence from the Control Authority to the permittee regarding compliance with this permit will be directed to the Authorized Representative identified in the application in Question A.3. The permittee shall be responsible for all requirements and information in correspondence directed to the attention of this designated individual, including but not limited to due dates. a. Should the permittee wish to change the Authorized Representative responsible to receive correspondence from the Control Authority a written designation must be submitted to the Control Authority indicating the name of the new Authorized Representative designated to receive compliance correspondence, their position in the company, a statement that they meet the requirements in part IV (15) of this permit, complete contact information, and an effective date of this designation.