6B(1) Blackthorn Golf Course Telephone System

Home Browse Search

AT&T STATEMENT OF WORK Blackthorn Golf Club Environmentals AT&T and Blackthorn Golf Club have agreed that a safe and healthy work environment will be provided to our respective employees and that each will comply with all local, state and federal laws and regulations governing job safety. It is the customer's responsibility to make known and correct any environmental or safety hazards that may be encountered during the work operations, including but not limited to the presence of friable asbestos. AT&T Responsibilities (General) AT&T will be responsible for the following: Serve as the central point of contact for all AT&T project related issues (e.g. client relationship issues, training coordination, change orders, project acceptance documents and project related correspondence). Conduct a site evaluation of the proposed equipment room prior to equipment shipment. AT&T Responsibilities (Specific) AT&T shall also provide the following services for Blackthorn Golf Club: 1. Install one (1) BCM50 with (6) T7316e Telephone Set W/MWI -Charcoal 2. Install (4) Test Central Office and/or Centrex Lines and (6) Tone, Tag and Test Customer's Present Cable At equipment room, terminate on an AT&T connection block(s). Provide labels and label connection block with jack number. At end-user location, terminate on RJ11-C flush mount or surface mount jacks where applicable. Label jacks on the inside with the jack number. Provide troughs at the top of each row. All new cable assumes a maximum 150 foot distance. Additional footage requirements will be billed on a time and material basis. All customer provided wiring must meet system specifications and must consist of one twisted or spiraled pair per phone; RJ11-C flush mount or surface mount jack at end-user location: a loop resistance of less than 59 ohms; a cable length of less than 1,000 ft. (24AWG) and contain no bridge taps. Wiring that does not conform to these parameters must be replaced at the customer's expense. An optional Norstar Auxiliary Power Supply may be purchased to extend the length of the loop from 1,000 ft. Up to 2600 ft. 3. Provide a log book outlining station numbers, jacks and locations for each end user where AT&T is installing new cable. Include RJ21X(s), trunk numbers and pin positions. If AT&T is reusing customer-provided wiring, the customer must provide a log book outlining station numbers, jacks and locations for each end-user. 4. Program KSU, test stations, and trunks All work will be performed during normal business hours 8:00 AM to 5:00 PM.