Laserfiche WebLink
<br />Page 2 of 4 PDS 09-1320 Revised April-2017 <br />Product Data Sheet <br />MULE-HIDE STANDARD REINFORCED AND FR REINFORCED EPDM MEMBRANE <br /> <br />SPECIFICATIONS - Continued <br /> <br />Ozone Resistance** <br /> Conditions after exposure 100 pphm <br /> Ozone in air for 168 hrs @ 104oF(40oC) <br /> Specimen wrapped around 3 inch mandrel <br />ASTM D 1149 No Cracks No Cracks <br />Resistance to Water Absorption* <br /> After 7 days immersion @ 158oF (70oC), <br /> Change in mass, max, % <br />ASTM D 471 +8, -2** 5.5** <br />Resistance to Outdoor (Ultraviolet) <br />Weathering - Xenon-Arc, exposure, 0.70 <br />W/m2 irradiance,176oF (80oC) black panel <br />temperature <br />ASTM G 155 <br />No Cracks <br />No Crazing <br />7,560 kJ/m2 <br />3,000 hours <br />No Cracks <br />No Crazing <br />33,320 kJ/m2 <br />14,000 hours <br />At 0.35 W/m2 irradiance,176oF (80oC) black <br />panel temperature <br /> 6,000 hours 28,000 hours <br />Fungi Resistance ASTM G21 N/A 0 (no growth) <br />*Typical properties and characteristics are based on samples tested and are not guaranteed for all <br />samples of this product. This data and information is intended as a guide and does not reflect the <br />specification range for any particular property of this product. <br />*Not a Quality Control Test due to the time required for the test or the complexity of the test. However, <br />all tests run on a statistical basis to ensure overall long-term performance of the sheeting. <br />***Specimens to be prepared from coating rubber compound, vulcanized in a similar method to the <br />reinforced product. <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br /> <br />PACKAGING <br /> <br />Mule-Hide Standard Reinforced and FR Reinforced EPDM Membranes (with and with-out tape) are available in a <br />variety of sizes with widths up to 10’ and lengths up to 100’ long. Contact Mule-Hide Products for available roll <br />sizes. <br /> <br />BENEFITS & SUPPLEMENTAL STATEMENTS <br /> <br />• Can be installed over a variety of roof decks <br />• Outstanding weatherability <br />• Sheets can be pre-taped for labor savings and consistent seam placement <br />• Requires no special equipment to install <br />• Available as a lightweight system <br />• Full line of pre-taped accessories available <br /> <br />CODE APPROVALS/COMPLIANCE <br /> <br />A variety of Factory Mutual Ratings and Underwriter Laboratory Classifications are available. Contact Mule-Hide <br />Technical Department for additional information. Meets or exceeds ASTM D4637, Type II for reinforced EPDM <br />single-ply membranes. <br /> <br />INSTALLATION INSTRUCTIONS <br /> <br />1) Approved insulation shall be attached to the roof deck with an approved insulation adhesive or approved <br />fasteners and plates. Install insulation with its largest dimension perpendicular to the direction of the <br />membrane seams where possible. <br /> <br /> <br />LEED Information <br />Pre-consumer Recycled Content 5% <br />Post-consumer Recycled Content 0% <br />Manufacturing Location Carlisle, PA or Greenville, IL <br />Solar Reflectance Index (SRI) 9