Opening of Quotes - The Monreaux Proj 125-066 - Big C Lumber Co

Home Browse Search

• Trusses with spans over 60' require extreme care and experience for proper and safe handling and erection. For general handling and erection guidance, see Guide to Good Practice for Handling, Installing, & Bracing of Metal Plate Connected Wood Trusses (BCSI), jointly produced by WTCA and TPI. For project specific guidance, consult with project engineer/architect/general contractor. Big C Lumber assumes no responsibility for truss handling, erection, or bracing. • Contractor is advised: BCSI-131 requires use of Spreader bar 2/3 to 3/4 the length of the trusses, even if not visible, trusses can be damaged if proper spreader bar is not used for truss erection. • Does not include any truss or hanger fasteners (Nails, Bolts, Screws not included) • Simpson A35 clips included at Roof truss to shear wall connections Floor Package: Supplied by SBC Loose • Floor Depth is Per Print 18" Typical, • Floors are at 24" O.C. loading TCD15/BCD10/TCL40 at living units. • Floors are quoted at L/480 Live load, and L/360 for Total Loads, this will need to be confirmed before Final Bid. • Floor is designed for Granite counter tops. • Floor designs can be stamped by an Engineer after final approval of design if needed. • Truss to Beam and Beam to Beam Hangers are included in package. • Floor is designed for 1" Gyp-crete flooring. Excluded from SBC Floor Truss Package • Does not include any truss or hanger fasteners (Nails, Bolts, Screws not included) • Materials and installation of Treated Decks • Materials and installation of any dimensional floor framing. • Materials and installation of Steel beams. • Materials or installation of Wood beams as headers, or not touching floor trusses. • Materials or installation or porch beams. • Materials and Installation of Draft Stop products. • Blocking for draft stops or strong backs. • Materials and installation of floor Sheathing. • Trusses are NOT FCS or fire treated. Any wood beams flush inside the floor plenum. • Simpson A35 clips included at Floor truss to shear wall connections o Any wood beams dropped directly touching the floor trusses. Any wood beams flush inside the floor plenum. General Notes: • All Corrosion Protection where dis-similar materials come in contact to be supplied and installed by rough carpentry labor package. • All sealants and adhesives installed and supplied by others. • Contractor is responsible for following all BCSI and Building Code bracing guidelines, which sometimes require retaining a registered professional engineer for the design of temporary bracing; this is NOT included in the SBCF's component package. • Project is bid off prints dated 08-13-25 ISSUED FOR BIDDING, this bid should be used for budgeting only, Big C will re -bid when Final documents are released. • Page 5501 detail #1 shows strapping needing to be installed before sheathing on shear walls. If this is the case, we will supply loose sheathing for these areas and the contractor will be responsible for applying sheathing in those areas.