Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Horton Emergency Vehicles

Home Browse Search

valve from the interior of the vehicle shall be by means of a hinged .250" thick Plexiglas® door in the forward wall of the action area. This opening shall be trimmed with a black, ABS formed bezel to protect the Technician's hands and provide a finished opening. The compartment shall be vented through the exterior door with a minimum 28 square inch opening. The vent opening shall be covered with a polished aluminum vent cover. It shall be attached with stainless screws. The oxygen cylinder retention bracket shall be mounted to the wall of the compartment by Grade 8 bolts tapped into a .250" aluminum plate welded onto the inboard side of the compartment wall. This retention bracket must meet or exceed AMD Standard 003, Oxygen Retention System. The finished oxygen system including regulator, contents gauge, hoses, outlets and flow meter must meet or exceed the requirements of AMD Standard 015, Ambulance Main Oxygen System Test. Y N 15.0 WIRING MODULE An angled cabinet forward of the rear facing Technician's seat shall house the main bank of electrical components. Adequate ventilation shall be supplied through two (2) polished metal, louvered vents located near the top and bottom of the door. YN 15.1 The cabinet shall have a vertically hinged door and shall be provided with a locking stainless -steel round latch. This door shall hinge on the left side for ease of maintenance and repair. Y N 16.0 WALK-THROUGH WITH POCKET DOOR There shall be an opening approximately 52" high x 20" wide between the chassis cab and the box module. Y�C N 16.1 An aluminum partition wall framed with .125" x 2" x 2" aluminum tubing placed on 16" centers and plated with .060" aluminum formed and welded to the roof, both sides, and floor shall be installed. The patient compartment side of the partition shall be covered with 1/4" plywood laminated with a minimum of .028" plastic. The driver's side of the partition shall be covered with the OEM wall as well as a mildew resistant marine style carpet of a color that matches the cab interior colors. Y Y `v N 17.0 EQUIPMENT FURNISHED The ambulance cab shall be equipped with an OEM supplied in -dash air conditioner and a hot water heater. The patient compartment shall be equipped with a combination hot water heater/air conditioner and a power exhaust vent. Front and rear heaters and air conditioners shall operate as separate and independent environmental systems. The controls for the rear environmental systems shall be located in the action area switch panel. The addition of the rear HVAC system shall have no deleterious effect upon the chassis system and especially the windshield defroster system as described in FMVSS 103, Windshield Defrosting and Defogging System. Y N 17.1 A combination heater/air conditioner having an air output of 650 cfm at 0 static pressure, a cooling capacity of 32,000 BTU and a heating capacity of 35,000 BTU shall be installed above the walk-through door on the front bulkhead. There shall be two insulated plenums running the full length of the modular body in the ceiling with (4) adjustable outlet vents in each plenum. There shall also be one adjustable outlet vent on the front bulkhead. This system shall be certified to KKK standards by a