Opening of Bids - One (1) or More, 2020 or Newer, Emergency Medical Vehicle – Spec P - Horton Emergency Vehicles

Home Browse Search

A full-length body rub rail shall be attached to both sides and extend from the body below the compartment doors. This rub rail shall be constructed of 1.5" x 2" x .250" "C" channel aluminum. The rub rails shall be attached to the lower margin of the body skirt using 1" x .25"-20 stainless steel flat head mounting bolts with stainless acorn nuts to the outside and plastic or nylon washers between the rub rail and body. For additional protection and for compliance with state highway requirements, two [2] heavy-duty composite mud flaps shall be installed behind the rear dual wheels. The mud flaps shall extend the full.width of each set of dual wheels. The mud flaps shall be black in color. 7.26 DRIVER AND PASSENGER CHASSIS STEPS There shall be a fuel tank cover with a recessed double step attached to the passenger side of the chassis cab and a driver side double step with an integrated flip down battery cover and roll out battery tray. The covers shall be constructed of .125" 3003 alloy aluminum diamond plate. There shall be a flip down step installed on passenger side forward and above of the recessed double step. To provide for increased road splash protection and ease of driver/technician entry and exit, fire grade aluminum diamond plate with an open grate diamond back non -slip stepping surface shall be installed on the chassis steps. 7.27 STONE GUARDS The lower 21" of the front module wall shall have an aluminum diamond plate stone guard TIG welded to ensure a secure fit. Stone guard shall not be screwed or pop riveted. The lower forward corners of the body shall have approximately 21" high aluminum diamond plate rolled around the corner radius and terminate at the junction of the cab and the body. The lower rear corners of the body shall have approximately 16.5" high aluminum diamond plate rolled around the corner radius and terminate at the rear kick plate area. 7.28 FENDERETTES Formed, rubber fenderettes shall be provided around each rear wheel well opening. They shall help diminish damage to the wheel well area of the body caused by stones and road debris. 7.29 LICENSE PLATE A Cast Products model #LP0002-1 rear license plate holder (or equal) shall be recessed into the rear of the body on the driver's side between the kick plate and turn signal. It shall be constructed of polished cast aluminum and have two [2] LED top lights to illuminate the plate. The bezel shall be mounted to the body with stainless steel screws and include a .060" thick closed cell foam gasket to prevent moisture from seeping behind the bezel. Y N YLN_ YXN_ Y4N_