Laserfiche WebLink
shall then be unmasked, inspected, and receive a minimum of 2 full wet coats of <br />certified urethane clearcoat. Topcoat will be baked again at 140 degrees for 30 <br />minutes. <br /> <br />Body is then color sanded, compounded, buffed, and polished to a smooth defect <br />free finish. <br /> <br />Upon final assembly, door hinges, hinge side of doorjambs and all stainless-steel <br />mounting hardware shall be coated with ECK, a corrosion inhibitor and permanently <br />mounted to vehicle. <br /> Y___N___ <br /> <br />25.2 BODY PAINT COLOR <br /> <br />The body shall be painted a single color of red with PPG base coat, clear coat paint <br />processes. Exact Color to be determined at pre-build <br /> Y___N___ <br />25.3 ROOF PAINT COLOR <br /> <br />The roof shall be painted a single color of white with PPG base coat, clear coat paint <br />processes. <br /> Y___N___ <br />25.4 SAFETY STRIPE <br /> <br />The body shall have a 2" wide reflective safety stripe around the entire perimeter <br />position above the main stripe. A QRS heartbeat shall be position on each side <br />towards the rear of the module. <br /> Y___N___ <br />25.5 REAR BARRICADE CHEVRON <br /> <br />There shall be 6'' solid red 983-72 diamond grade reflective 60-degree stripes and 6'' <br />fluorescent yellow green 983-23 diamond grade reflective stripes across the entire <br />back of the ambulance. This design shall provide the greatest amount of reflectivity <br />for the overall safety of the vehicle and crew. The chevron pattern shall slant <br />downward on both sides on the rear of the vehicle at an angle of 60 degrees, <br />pointing in the direction of the bottom rear corner of the tailboard. The pattern should <br />resemble an inverted V with the point at the top center of the ambulance. <br /> Y___N___ <br />25.6 MAIN SCOTCHLITE STRIPE <br /> <br />A white main Scotch lite stripe shall be provided, "Straight" design on the chassis <br />and body sides (including the rear body). It shall start at the front of the module and <br />run along each side of the body. The main stripe shall wrap around the rearward <br />section of the body, completing the perimeter. The main stripe shall not exceed 14 <br />inches in width. Scotch lite color, stripe dimension and layout shall be provided by <br />the department after award of bid. <br /> Y___N___ <br /> <br />25.7 PINSTRIPING <br /> <br />There shall be 1/4" wide black vinyl pinstripes around the entire perimeter of the <br />body, positioned above and below the main color stripes. <br /> Y___N___ <br /> <br />25.8 RUBRAIL SAFETY STRIPE