Laserfiche WebLink
forward of the rear wall. To provide protection for the equipment retained in the <br />compartment, the divider shall be Line-X coated. <br /> Y___N___ <br /> <br /> <br />7.16 SCBA MOUNTING PLATE <br /> <br />The mounting plate shall be 24'' high and run the full width of the compartment. The <br />mounting plate shall be made of 3/16'' smooth aluminum with rolled top and edges <br />and have a 3/4'' lip. There shall be a 1" x 2" aluminum tube welded to the back of the <br />SCBA plate and mounted to the lower rear wall of the D4 compartment. <br /> Y___N___ <br /> <br />7.17 EQUIPMENT RETAINERS <br /> <br />Three (3) seatbelt style retainer straps shall be provided and installed in the P5 <br />exterior compartment. One (1) shall be located in the aft section 40" from the floor <br />and two (2) located in the fore section 17" and 54" from the floor. <br /> Y___N___ <br /> <br />7.17.1 A slide out stair chair holder for a Stryker model # 6252 stair chair shall be provided in the aft <br />section of the P5 compartment under the adjustable shelf. The holder shall be constructed of .125” <br />smooth aluminum with the entire holder covered with black Line-X bed-liner type material. The back shall <br />be 38” high, the front shall be at a slight outward angle and be 27” high. It shall be 22” wide and 9” deep. <br />Dimensions shall allow for easy removal of device from holder. <br /> <br />A seat belt style retaining strap shall be secured to the back with footman loops. The stair chair holder <br />shall be mounted into the compartment with two (2) 300 lbs., full extension ball bearing drawer slides. <br /> Y___N___ <br /> <br />7.18 SAFETY REFLECTORS <br /> <br />A 4.5" wide x 1" high red reflector shall be provided and installed on the inside, lower <br />outboard area of each exterior door. These reflectors shall warn oncoming traffic of <br />the open door while on scene. <br /> Y___N___ <br />7.19 GRAB RAIL <br /> <br />An exterior style 16" stainless steel grab rail shall be installed on the curbside of the <br />vehicle to the rear of the curbside entrance door. The grab rail shall be bolted <br />through the body skin and through the aluminum side structure with fender washers <br />and lock nuts on the interior and rubber gaskets under the feet of the grab rail on the <br />exterior. A grab rail mounted to the body skin is unacceptable. <br /> Y___N___ <br />7.20 SIDE BODY SEAMS <br /> <br />All side center body seams are to be MIG welded, fully filled and body finished to <br />create a smooth, blemish free surface for final finishing and painting. There shall be <br />no side body molding applied or required. <br /> Y___N___ <br />7.21 REAR BUMPER <br /> <br />The rear step bumper shall be approximately 94" wide and step tread depth of 10.5". <br />The bumper shall be supported with a 1.5” x 1.5” x .250” wall steel tube sub frame <br />and have .250" steel angle outer frame construction. The bumper shall be bolted to <br />the vertical web of the chassis frame rails with .375” x 1.5” Grade 8 bolts, nuts and