Laserfiche WebLink
Liberty Tower Exterior Renovations - Ph 2 <br />South Bend, Indiana <br />C. Mock-up may remain as part of the Work. <br />1.6 FIELD CONDITIONS <br />© Copyright, Kil Architecture / Planning <br />September 2020 <br />A. Do not prepare materials or apply EIFS under conditions other than those described in the <br />manufacturer's written instructions. <br />B. Do not prepare materials or apply EIFS during inclement weather unless areas of installation <br />are protected. Protect installed EIFS areas from inclement weather until dry. <br />C. Do not install coatings or sealants when ambient temperature is below 40 degrees F. <br />D. Do not leave installed insulation board exposed to sunlight for extended periods of time. <br />1.7 WARRANTY <br />A. See Section 017800 - Closeout Submittals, for additional warranty requirements. <br />B. Provide manufacturer's standard material warranty, covering a period of not less than 5 years. <br />PART 2 PRODUCTS <br />2.1 MANUFACTURERS <br />A. Basis of Design: <br />1. Dryvit Systems, Inc; Dryvit Outsulation EIFS, Class PB: www.dryvit.com/gsle. <br />B. Exterior Insulation and Finish Systems Manufacturers: <br />1. Dryvit Systems, Inc; Dryvit Outsulation EIFS, Class PB: www.dryvit.com/gsle. <br />2. BASF Wall Systems; Senergy Channeled Adhesive Cl Design: <br />www.wallsystems.basf.com/#sle. <br />3. Parex USA, Inc; Standard WaterMaster LCR Cl: www.parex.com/gsle. <br />4. Substitutions: See Section 01 6000 - Product Requirements. <br />2.2 EXTERIOR INSULATION AND FINISH SYSTEM <br />A. Exterior Insulation and Finish System: BARRIER type; reinforced finish coating on insulation <br />board adhesive -applied direct to substrate; provide a complete system that has been tested to <br />show compliance with the following characteristics; include all components of specified system <br />and substrate in tested samples. <br />B. Fire Characteristics: <br />1. Flammability: Pass, when tested in accordance with NFPA 285. <br />2. Ignitibility: No sustained flaming when tested in accordance with NFPA 268. <br />3. Potential Heat of Foam Plastic Insulation Tested Independently of Assembly: No portion <br />of the assembly having potential heat that exceeds that of the insulation sample tested for <br />EXTERIOR INSULATION AND 07 2400 - 2 <br />FINISH SYSTEMS <br />