Opening of Bids - Seitz Park Reconstruction Phase I Proj No. 117-093A - Northern Indiana Construction Co., Inc.

Home Browse Search

FENDER LINERS Full -circular, aluminum, inner fender liners in the wheel wells shall be provided. Surface to match cab interior. WINDSHIELD A one (1) or two (2) piece, safety glass windshield with more than 2,600 square inches of clear viewing area shall be provided The windshield shall be full width and shall provide the occupants with a panoramic view. The windshield shall consist of three (3) layers: the outer light, the middle safety laminate, and the inner light. E O SUNVISORS Two (2) solid sun visors shall be provided The sun visors shall be located above the ES O windshield with one (1) mounted on each side of the cab. WINDSHIELD WIPERS Electric windshield wipers with a washer, in conformance with FMVSS and SAE requirements, shall be provided The windshield washer fluid reservoir shall be located at the front of the vehicle. CAB REAR WALL EXTERIOR COVERING The exterior surface of the rear wall of the cab shall be overlaid with bright aluminum treadplate except for areas that are not typically visible when the cab is lowered CAB LIFT A hydraulic cab lift system shall be provided, consisting of an electric -powered hydraulic pump, fluid reservoir, dual lift cylinders, remote cab lift controls and all necessary hoses and valves. The hydraulic pump shall have a backup manual override, for use in the event of an electrical failure. The rear of the cab shall be locked down by a two (2)-point, automatic, hydraulic, double hook mechanism that fully engages after the cab has been lowered (self-locking). The dual 2.25 " diameter hydraulic cylinders shall be equipped with a velocity fuse that protects the cab from accidentally descending when the cab is in the tilt position. For increased safety, a redundant mechanical stay arm shall be provided that must be manually put in place on the driver side between the chassis and cab frame when cab is in the raised position. This device shall be manually stowed to its original position before the cab can be lowered. INTERLOCK, CAB LIFT TO PARKING BRAKE The cab lift safety system shall be interlocked to the parking brake. The cab tilt mechanism shall be active only when the parking brake is set, and the ignition switch is in the on position. If the parking brake is released, the cab tilt mechanism shall be disabled GRILLE A bright finished grille shall be provided on the front center of the cab and shall serve as an air intake to the radiator. MIRRORS Dual vision, motorized, west coast style mirror, with chrome finish, shall Be mounted on each side of front cab door with spring loaded retractable arms. The flat glass and convex 23