Laserfiche WebLink
GAPS, SEALANT Ei JOINTS <br />• Seal all gaps with a high-quality, non -hardening, paintable <br />sealant with a minimum stated service life of 30 years. <br />Follow the sealant manufacturer's instructions for <br />application. <br />•GABLE ENDS <br />At gable ends, a backer board (such as a barge rafter) should be <br />used under fascia to provide maximum support along the length <br />of the product (see Diagram A). <br />• If LP SmartSide trim and fascia is installed directly to lookouts <br />on an overhanging rake, the lookouts must be installed <br />edgewise and must be spaced no wider than 24" O.C. (see <br />Diagram B). <br />DIAGRAM A DIAGRAM B <br />N <br />n rafter <br />d or verge <br />er <br />e rafter <br />2x or 4x lookouts <br />DO <br />common rafter <br />ge rafter <br />its the some <br />rs&016'or <br />24'0.C. provides strength and <br />nailing for boxedTn take <br />Install drip -edge or' <br />drip -cap to prevent.41`:v' �_ <br />water bulldup behind w$ <br />fascia and trim. <br />FASCIA DETAIL FASCIA <br />SOFFIT <br />TRIM <br />• Prime and paint all exposed surfaces. <br />• Apply finish coat as soon as possible or within 180 days <br />of application. <br />• High-quality acrylic latex paint, specially formulated for <br />use on wood and engineered wood substrates, is highly <br />recommended. Semi -gloss or satin finish oil or alkyd paints <br />are acceptable. For flat alkyd paint, please check with the <br />coating manufacturer for their recommendations for use on <br />composite wood siding. <br />• Follow the coating manufacturer's application and <br />maintenance instructions. <br />3 <br />DO NOT USE <br />A <br />r. <br />• <br />Sem 1-transpare nt and transparent stains. <br />• Shake and shingle paints. <br />• Vinyl -based resin formulas such as vinyl acetate, PVA, <br />vinyl acetate/acrylic copolymer paints. <br />APPLICATION INSTRUCTIONS (CONT.) <br />• Store off the ground on a flat surface, under a roof or <br />separate waterproof covering. <br />• Keep trim and fascia clean and dry. inspect prior <br />to application. <br />• Allow trim and fascia to adjust to atmospheric conditions <br />before application. <br />r=� <br />STORE TRIM <br />FLAT ON STRINGERS <br />The Louisiana-Pacific Corporation ("LP") LP SmartSidetrim and <br />fascia (the "Products") limited warranty (the "Warranty") applies <br />only to structures on which the Products have been applied, finished <br />and maintained in accordance with the published application, <br />finishing and maintenance instructions in effect at the time of <br />application. The failure to follow such application, finishing or <br />maintenance Instructions will void the Warranty as to the portion of <br />the Products affected by the variance (the "Affected Products"). <br />LP assumes no liability for any loss or damage sustained by the <br />Affected Products and is expressly released by the purchaser or <br />owner from any such loss or liability. <br />Any modification of the Warranty's application, finishing or <br />maintenance requirements is void and unenforceable unless <br />approved in writing prior to application by the Siding Business <br />Manager or his designee and a member of the LP Legal Department. <br />For a copy of the warranty or for installation and technical support, visit the <br />LP SmartSide product support Web site at: <br />www.lpcorp/smartside.com <br />or for additional support call 800AS0.6106. <br />WARRANTY REMEDIES ARE NOT AVAILABLE IF <br />REQUIREMENTS ARE NOT FOLLOWED. <br />SMARTSIDE` <br />TRIM 6 SIDING <br />BUILDING PRODUCTS <br />0 2007 Louisiana-Pacific Corporation, All rights reserved. LP and SmartSide are registered trademarks <br />of Louisiana-Pacific Corporation. Printed in U.S.A. _ <br />NOTE: Louisiana-Pacific Corporation periodically updates and revises Its product information. <br />To verify that this version is current, call 800-4S0-6106. LPZB0024 <br />