Laserfiche WebLink
III �'����„������� 1� III "�� SHALL BE <br />AS <br />,TYPE DESCRIPTION SPECIFIEI <br />(Circle One) <br />The Melonized surfaces shall have a predominance of single phase <br />epsilon nitride. The nitride shall cover the entire cylinder surface. <br />This shall give the cylinder superior wear and corrosion resistance <br />and also shall have superior wear and fatigue properties. <br />The cylinder rod shall be c 1045/c 1050 steel with a tensile strength <br />of 80,000 to 1,000,000 pounds. <br />The cylinder tubing shall be D.O.M. Tubing, drawn over a <br />mandrel, and shall have tensile strength of 70,000 pounds. The <br />tube shall have a surface harness of 80 Rockwell `B". <br />The cylinder shall dismantle easily and overlap between stages for <br />greater stability. <br />The trunnion collar shall be oscillation <br />Each rod or pin eye shall have a zerk. <br />Ladder: <br />There shall be a fold up stainless ladder located at the driver side <br />YE / NO <br />front corner of the body for easy entrance to the dump body. In <br />gyro „ <br />addition, there shall also be a welded stainless step type insert on <br />the front driver's side on the inside of the body. <br />D-Rings: <br />Bed shall have 3 D-Rings on each side of bed to mount leaf box. <br />Y91;/ NO <br />The D rings shall be mounted in approved location and place as <br />what the City currently has on their fleet trucks. <br />Tarp Rods: <br />There shall be 2" wide stainless grip strut walk rails located on the <br />q NO <br />sides of the body. Tarp rods shall be installed in approved location <br />and placed as what the City currently has on their fleet trucks. <br />Tarp: <br />Tarp system should be of the same system that is presently used by <br />E, NO <br />the City now and shall be installed in a like manor. System shall be <br />� <br />a Pull Tarp system with parts that interchange with City's existing <br />traps. <br />Shall have a minimum of three (3) brackets (each side) - 2 "x 4" flat iron minimum, at least one at rear, <br />one in center, one at front. Shall be welded at rear and bolted with three (3) 5/8" bolts per bracket <br />(minimum). Hoist cylinder shall be hooked to central hydraulics with 3/4" high pressure hose (two <br />15 <br />