Laserfiche WebLink
I:Hled 4'ti bro A J <br />acceptao6f <br />Hydraulic lines shall be routed to minimize interference <br />with equipment and chassis components requiring periodic <br />servicing. Appropriate support brackets, grommets, and tie <br />wraps shall be provided to protect lines from abrasion, <br />cutting and impact damage, Hoses shall not be installed <br />near manifold or exhaust pipes so as to be affected by <br />extreme heat. There shall be no pipe fitting used with any <br />high pressure lines. Any and all hydraulic quick disconnect <br />couplings used for spreader system and snow plow <br />reversing system shall be of the bulkhead mounted style <br />and be rigidly attached without the use of any hose clamp <br />arrangements (loose hose ends are NOT acceptable), Couplers to <br />be mounted to side of dump bed so they do not get covered with <br />material or broken. Dust cap for male ends and dust plug for <br />female ends must be attached to couplers. Maximum distance <br />allowed between support clamps on all hydraulic hoses shall be <br />approximately 24". <br />Electronic The spreader control will utilize PWM technology to QDES NO <br />Manual control the variable feed and spread widths. The feed rate <br />Spreader knob will accommodate 9 different settings while the <br />Control: spread width knob will also accommodate 9 settings. The <br />control head will have a power switch with an indicator <br />lamp to provide status on the operation of the controller. Unit to <br />be <br />mounted for safe use by driver. <br />Controller shall be Storm Guard Freedom 2, controller. <br />Spreader control shall have ability to be touch screen with usb <br />data <br />download. <br />TEP wiring harness. <br />Screw on cap and plug set for motor sensor connection. <br />Detailed operators manual. <br />Calibration manual. <br />Wiring diagrams, <br />Spreader Control Harness System: <br />Spreader control and the hydraulic valve shall be connected via <br />TPE harness system. <br />20 <br />