Laserfiche WebLink
FNed h'i by W A Jm oes <br />Pump shall have a,shutdown circuit, Circuit shall be energized by <br />a tank mounted float to shut off pump flow in the event of a low <br />oil condition. <br />Shutdown system shall have a cab mounted system override switch. <br />Mounting: The hydraulic pump shall be mounted with shaft centerline <br />parallel to the crankshaft centerline and at a level to create not <br />more than a three degree angle on the drive line. The pump <br />mounting shall be incorporated with a bracket fabricated to <br />mount in the extended rails from the pump. <br />Driveline: The hydraulic pump shall be driven directly off the engine <br />crankshaft via a splined driveline to allow for movement. The <br />driveline shall include grease fittings on both u-joints. Spicer <br />model 1310 series or equal. <br />Reservoir: The hydraulic reservoir shall be of the slim line type and <br />shall be mounted between the chassis and the dump body. <br />The mounting of the reservoir shall not extend the cab to <br />axle dimension of the chassis. <br />The hydraulic reservoir shall be 40-gallon capacity and be <br />equipped with the following: Basket type filler breather <br />cap, magnetic drain plug, 2" NPT suction with 100-mesh <br />screen type filter, separate return port for control drain line, <br />sight temperature gauge externally mounted, internal <br />baffling, heavy duty 1 1/4" ball type shut off valve shall be <br />mounted on the suction side. <br />Hydraulic Lines All hydraulic lines, pipes, hoses, and fittings shall be of <br />& Plumbing: sufficient capacity to accommodate the volume of oil <br />without undue heating or turbulence in the system. A 2" <br />suction line with a minimum SAE rating of 100-R4 must be <br />used between the reservoir and the inlet of the pump. This <br />suction hose shall be secured on both ends via heavy duty <br />banding straps, radiator hose clamps unacceptable. All of <br />the pressure hoses, including the signal sensing line to the <br />pump must have swivel fittings on BOTH ends and have a <br />minimum SAE rating of 100-112. Return lines and the case <br />drain line must have a minimum SAE rating of 100-R1. <br />All fittings shall be JIC. Push on clamp fittings are not <br />19 <br />YES NO <br />YES NO <br />YES NO <br />YES NO <br />