Laserfiche WebLink
CITY OF SOUTH BEND <br />Hold Open, Gas Strut, CS Entry Door, 35# Standard. <br />CURBSME ACCESS DOOR HOLD OPEN <br />The curbside access door shall have a gas strut hold opm to hold the door at <br />approximately 90 degrees. <br />Panels, Entry, Durasafe, Stainless Steel, wl Chavrons, STD <br />DOOR PANELS <br />The upper and lower portion of the curbside and rear access door panels shall be <br />brushed stainless steel. The center shall be reflective chevron covered aluminum. <br />Flare, Fender, Briaht Finish, Std Model oni . <br />REARFENDERS <br />Bright finish aluminum fender flares shall be provided around the rear wheel well <br />openings to provide protection from wheel wash. A corrosion inhibitor shall be <br />applied to the mounting holes prior to installation. <br />Bum per,Rear, Frt1nr/1nt'1,Std,W/Sk1ds, No Liahts <br />BUMPERS AND STEP <br />The chassis manufacturer shall supply the vehicle's front bumper. The rear <br />bumper and step assembly shall be a single unit constructed of ten gauge steel "C', <br />formed channel and . 100 inch thick aluminum tread plate as measured at the <br />thinnest point of the tread plate. The center step of the bumper assembly shall be <br />designed to allow it to flip up and out of the way to facilitate patient loading. The <br />flip up section of the of the rear bumper shall be diamond plate to meet the <br />requirements of KKK-A-1822-F specification. The diamond plate flip up step <br />shall be punched with three rows of raised star -shaped holes to create additional <br />non-skid surface. A 1.5" x 2" x 0.125" aluminum box tube shall be welded inside <br />the step full width on the side farthest from the rear of the vehicle. A stainless <br />steel hinge with a center pin of .250 inch shall be used to attach the flip up section <br />of the rear step to the main rear bumper assembly. There shall be eye bcarn <br />constructed skid plates with tow eyes mounted as part of the frame of the bumper. <br />This assembly shall be bolted to the frame of the chassis with 5/8 inch Grade 8 <br />bolts. There shall be a one half inch clearance between the bumper assembly and <br />the rear of the modular body to allow water drainage and inhibit water collection. <br />Dock Bumpers, 3 - Hole, Black, on Rea <br />REAR DOCK BUMPERS <br />Dock bumpers shall be installed on each outboard pontoon on the rear bumper. <br />The dock bumpers shall measure 10 inches wide and 4 t/2 inches high and 3 <br />inches deep. <br />10083-0016 08127/18 <br />21 <br />